Installation - Magic Capppuccino RS SIN 017R Operating Instructions Manual

Table of Contents

Advertisement

Installation

4
INSTALLATION
For your own safety and the safety of
others, you must strictly comply with
the “Safety Rules” described in chap.3
4.1
Package
The original packaging was designed and
made to protect the machine during
shipping.
We recommend keeping it for future
transport purposes.
4.2
Installment requirements
Before installing the machine read the
following safety instructions carefully:
• Locate the machine in a safe place;
• Make sure that it is out of the reach of
children;
• Do not place the machine on a hot
surface or near a naked flame.
The machine is now ready to be connected
to the house electricity supply.
4.3
Electrical hook-up
Electricity can be dangerous,
so always follow the safety
regulations carefully.
Never use a faulty cable.
Faulty plugs and cables must
be changed immediately by authorised
personnel.
The coffee maker must be connected to a
suitable wall socket.
The voltage of the appliance has been
factory-set.
The voltage on the rating plate (positioned
on the bottom of the appliance) must
correspond to that of your house electricity
supply.
• Check that the main switch is in the “0”
position before inserting the plug in the
wall socket.
• Plug the appliance into a wall socket
carrying the correct voltage.
4.4
Filling the water container
Take out the water container (1);
14
an automatic device will raise the water
aspiration tube.
Rinse it out and fill it with fresh
15
drinking water; do not overfill.
Set the container back in place;
17
press firmly to activate the automatic
device that immerses the aspiration tube
in the water.
Always fill the tank with fresh,
not carbonised water: hot
water or other liquids may damage
the tank.
Do not use the coffee maker
without water, always check
that there is enough water in the tank.
4.5
Loading the circuit
Before starting the machine, after it has been
inoperative for a lengthy period and all the
water has been used up, you must reload
the circuit.
• Press the main switch (3); the light inside
the switch will go on.
Direct the steam tube over the drip
18
tray.
• Turn the “hot water/steam” knob (6)
counterclockwise to open and press the
coffee switch (4).
23

Advertisement

Table of Contents
loading

Table of Contents