Using A New Card; Lamp Indicators - Olympus FE-250/X-800 Instruction Manual

Olympus digital camera instruction manual
Table of Contents

Advertisement

Movies
Image quality
SHQ
HQ
• When the [IMAGE QUALITY] is set to [SHQ], the continuously recording
length of the card other than the TypeH is up to approx. 15 seconds.

Using a new card

• If you use a non-Olympus card or a card used for another application, such
as a computer, the message [CARD ERROR] is displayed. To use this card
with this camera, use the [FORMAT] function to format the card.
g "MEMORY FORMAT (FORMAT) Formatting the internal memory or card"
(P. 26)

Lamp indicators

This camera uses several lamps to indicate the camera status.
Self-timer lamp
Card access lamp
Green lamp of the
monitor
50
EN
Image size
640 × 480
(30 frames/sec.)
320 × 240
(30 frames/sec.)
Lamp
The lamp lights for approximately 10 seconds, blinks for
approximately 2 seconds, and then the picture is taken.
Lit (red): Shooting mode
Lit (green): Playback mode
Unlit: Power is off.
Blinking (red): A picture is being recorded, the camera is
reading a movie, or images are being downloaded (when
connected to a computer).
• Do not do any of the following while the card access lamp
is blinking. Doing so may prevent the image data from
being saved and render the internal memory or card
unusable.
• Open the battery/card compartment cover
• Remove the battery
Lit: The focus and exposure are locked.
Blinking: The focus and exposure are not locked.
• Release your finger from the shutter button, re-position
the AF target mark on the subject and press the shutter
button halfway again.
Remaining recording time
Internal memory
With
Without
sound
sound
11 sec.
11 sec.
30 sec.
30 sec.
Status
Using a 512 MB card
With
Without
sound
sound
4 min.
4 min.
42 sec.
43 sec.
12 min.
12 min.
42 sec.
53 sec.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fe-250X-800

Table of Contents