Table of Contents
Advertisement
40
Before you call for service, review the following list. The list includes common occurrences that are not the result of
defective workmanship or materials in this appliance. It may save you time and expense.
Problem
Appliance is not level
Cannot move appliance easily.
Appliance must be accessible for
service
Entire appliance does not operate
Oven does not operate
Oven light does not work
Flames inside oven or smoking from oven vent
Oven control panel beeps and displays any F code
error (for example F10)
Oven racks do not slide easily
Glide racks do not slide smoothly
Questions or for service call: 1-877-4 ELECTROLUX (1-877-435-3287)
Solution
•
Be sure floor of the cabinet or built-in is level, strong and stable
enough to adequately support oven. If floor is sagging or sloping,
contact a carpenter to correct the situation.
•
Poor installation.
•
Kitchen cabinet alignment may make oven appear not level. Be
sure cabinets are square and have sufficient room for appliance
clearance.
•
Cabinets not square or are built in too tightly. Contact builder or
installer to make appliance accessible.
•
The time of day is not set. The time of day must first be set in order
to operate the oven. See
Controls section.
•
Make sure cord is plugged or wired correctly into outlet.
•
Service wiring is not complete. Contact your dealer, installing agent
or authorized service agent.
•
Electrical power outage. Check house lights to be sure. Call your
local electric company for service.
•
Be sure the oven controls are set properly for the desired cooking
feature. See
"Setting Oven Controls"
read the instructions "Entire appliance does not operate" in this
checklist.
•
Replace or tighten bulb. See
Oven Lights"
in this Use and Care Guide.
•
Excessive spills in oven. For example this will happen for pie spills
or large amounts of grease left on the oven bottom. Wipe up
excessive spills before starting oven. If flames or excessive smoke
are present see
"Broil"
in the Setting Oven Controls section.
•
Oven control has detected a fault or error condition. Press CANCEL
to clear the display and stop beeping. Try the bake or broil feature
again. If F code error repeats, remove power supply to appliance,
wait 5 minutes and then repower the appliance. Set clock for the
time of day. Try the bake or broil feature again. If the fault recurs,
record fault code and call for service.
•
This oven comes with lubricated porcelain oven racks, which can
remain in the oven during the clean cycle. Do not clean this
vegetable oil lubrication off the racks. It is important that the sides of
the oven racks always have a light coating of vegetable oil. To
maintain optimal rack performance, re-apply a thin layer of
vegetable oil to the sides of the rack after every clean cycle or when
the rack becomes difficult to slide.
•
Glide racks need lubrication. For instructions on how to care for
your oven racks, See
"Caring for your porcelain enameled glide
racks"
on page 38.
Solutions to Common Problems
"Setting the Clock"
in the Setting Oven
in this Use and Care Guide or
"Replacing the Dual Left or Right Side
- Quick Links:
- Solutions to Common Problems
Hide quick links:
Advertisement
Table of Contents
