Advertisement
.!
Problem
Possible Causes
What to Do
Washer is unplugged
Make sure cord is plugged
securely into a
working
outlet.
Water supply is turned off
. Turn both hot and cold faucets fully on.
Controls are not set properly
Check controls
and make sure Cycle knob
is pulled out to ON position.
Lid is open
Close lid and pull Cycle knob out to ON
position.
Circuit breaker/fuse
is
Check house circuit breakers/fuses.
Replace
tripped/blown
fuses or reset breaker.
Washer should have
separate outlet.
Control is not set properly
Check water temperature
control
and adjust.
Water supply is turned off
Turn
both
hot and cold Faucets fully on and
or
improperly connected
make sure hoses are connected
to correct
faucets.
Water valve screens are
Turn off the water source and remove
the
stopped up
water connection
hoses from the upper back
of the washer. Use a brush or toothpick
to
clean the screens in the machine.
Reconnect
the hoses and turn the water back on.
House water heater is not set
Make sure house water heater is delivering
properly
water at 120"F.-15O"F.
(48"C.-65"C.).
Drain hose is kinked or
Straighten
drain hose and make sure
improperly connected
washer is not sitting on it.
Top of drain outlet should be less than 8 ft.
above floor.
Fill hoses or drain hose is
improperly connected
Make sure hose connections
are tight at faucets
and make sure end of drain hose is correctly
inserted in and secured
to drain Pacility.
16
Household drain may
Check household
plumbing.
You may need
be clogged
to call a plumber.
Advertisement
