Table of Contents
Advertisement
7.1 Ethernet and Telnet configuration commands
Configure the ATTO FibreCenter 3400 using a Telnet session over the Ethernet port. The commands in
this section configure or provide information about the Ethernet port and the Telnet session.
Default Router
Sets a new default router address for the Telnet server. Set the default router within the subnet as defined by the subnet mask and IP Address.
Limit: 0-255
Action: set•RACK •000•Default•Router•[n.n.n.n]
reset•rack•000 or power cycle
Echo
Sets the Telnet command echo mode.
Limits: [on|off]
Action: set•RACK •000•Echo•[on|off]
reset•rack•000 or power cycle
Factory Defaults
The Telnet parameters are set to their factory default values.
Action: set•RACK •000•Factory•Defaults
reset•rack•000 or power cycle
Idle Timeout
Sets time period in seconds after which, if there is no action on the Telnet port, the Telnet session is shut down.
Action: set•RACK •000•Idle•Timeout•[n]
reset•rack•000 or power cycle
IP Address
Sets a new IP address which will be used after next reset.
Limit: 0-255
Action: set•RACK •000•IP•address•[n.n.n.n]
reset•rack•000 or power cycle
Security Traps
Sets the Telnet security level
Action: set•Security•Traps•[n]
reset•rack•000 or power cycle
Subnet Mask
Sets a new subnet mask which will be used after next reset.
Limit: 0-255
Action: set•RACK •000•Subnet•Mask•[n.n.n.n]
reset•rack•000 or power cycle
Telnet
Ends the current Telnet session and opens another
Action: Telnet
Telnet Status
Returns the Telnet status. The format will be determined in the future.
15 ATTO FibreCenter 3400
tallation and Operation Manual
Ins
Default: 0.0.0.0
Information: get•RACK •000•Default•Router
Information: get•RACK •000•Echo
Information: none
Default: 60 minutes
Information: get•RACK •000•Idle•Timeout•[n]
Default: 192.168.1.1
Information: get•RACK •000• IP•Address
Default: 3
Information: get•RACK •000•Security•Traps
Default: 255.255.255.0
Information: get•RACK •000•Subnet•Mask
Information: none
Advertisement
Table of Contents
