Advertisement
3.1 REMOVAL
AND
INSTALLATION
OF
DETECTOR LEVER UNIT
1. Hold the detector lever unit with yourrighthand
as shown in Flg. 3-1, open the PU plate (A) and
PU plate (B) of the PU plate (B) assembly with
your
left hand, and careftdly pull out the
detector lever unit upward.
2. Install the detector lever unit in reverse sequence
of the removal. lt this case, however, note that
the detector lever unit will be bent when the pin
portion (A) is in contact with the detector lever
unit and the detector lever unit is pushed hard.
3.2 REMOVAL AND INSTALLATION OF PU
PLATE (B} ASSEMBLY
1. Remove the base plate and remove the PU board
plate.
2. Insert a slightly Iong screwdriver into the turn-
table through the opening on the back of
the turntable as shown in Fig. 3-3, and remove
the screw used to fix the PU plate (B) assembly.
3. Install the PU plate (B) assembly in reverse
sequence of the removal. In this case, however,
install the PU plate (B) assembly so thatthe mark
on the panel is on tJre line extended from the
side panel of the PU plate (B) (Fig.3-a).
P U p l a t e ( B ) -
plate (A)
Screwdriver
etector lever unit
F i g . 3 - 1
lever unit
(
Fi9. 33 Remove PU plate (B)
Fig. 3-4 Attach PU plate (B)
Tonearm
assembly
PU plate (B)
wq/
-v/
Remove detector
PU board
PU plate (B)
PU plate (B)
Panel
Green
Fig. 3-2 Attach detector lever unit
Fig. 3-5 Disconnect the tonearm lead wires
Advertisement
