Using The Remote Setup Function - LG LRN8240D Series Owner's Manual

54 LG Network Client Program

Using the Remote Setup function

You can set the DVR/NVR configuration of a selected site name
using this function.
System settings
Date/Time
• Date Format: Select the date display format.
• Time Format: Select the time display format.
5
• Time Zone: This option setting is not available in the client
program.
• Daylight Saving: Mark up when you use the daylight saving
function.
• Start Time: Select the Daylight Saving start time.
• End Time: Select the Daylight Saving end time.
Properties
• DVR/NVR Name: Enter the DVR/NVR name by using alphabetic
letter, numeric digit and symbols up to 21 characters. The
number of maximum characters is depends on the language.
• Language: Select a language for the setup menu and
information display of the DVR/NVR.
• Button Beep: Mark up to activate the button beep. The button
beep is activated when using the buttons.
• Video format: These option settings are not available in the
client program.
NOTE
This option is not supported for model LRN8240D.
• Resolution: These option settings are not available in the client
program.
NTP
• NTP: Mark up, if you want to synchronize the DVR/NVR's date
and time with those of the time server called NTP (Network
Time Protocol) Specify the NTP server's name.
• Time Server: For most cases select public. The DVR/NVR will
obtain the average time among 5 public servers (time.nist.gov,
time-a.nist.gov, time-b.nist.gov, ntp.nasa.gov, clock.isc.org).
• Private Time Server: Enter the private time server's IP address or
host name.
• Sync. Interval: You can set synchronized intervals with the NTP
time server to 1 day, 1 hour, 1 month and 1 week.
Network
These option settings are not available in the client program except
the [Bandwith Throttle] option.
• Bandwidth Throttle: Enter the Bandwidth to adjust the data
traffic.
DDNS
These option settings are not available in the client program.
Network Streaming
1. Click the [Setup] button to display the Network Streaming
configuration window.
• Ch: Displays the channel number.
• Resolution: Selects the recording resolution. Each group
such as "Ch1 to Ch8" and "Ch9 to Ch16" are set the same
resolution.
• Quality: Selects the recording picture quality.
• Frame Rate: Selects the frame rate. The frame rate is the
number of transportable frames per second. According to
resolution, the frame rate is set automatically. If you wish to
set manually, refer to the below.
Resolution
352*240
NTSC 704*240
704*480
352*288
PAL 704*288
704*576
2. Click the [OK] button to confirm the settings.
NOTE
This option is not supported for model LRN8240D.
Controller
• IR Remote ID: Select the IR Remote ID for this unit. If you use
multi systems set the IR Remote ID for each DVR/NVR unit.
• Remote Controller ID: Select the Remote Controller ID for this
unit. If you use multi systems, set the Remote Controller ID for
each DVR/NVR unit. You can control the DVR/NVR by using
the LKD1000 controller. (For more details refer to the LKD1000
owner's manual.)
Device settings
Camera
• Channel: Select the channel number.
• Name: Enter the channel name by using alphabetic letter,
Frame Rate
1, 3, 5, 7.5, 10, 15
1, 3, 5, 7.5
1, 3
1, 3, 5, 6, 7.5, 12.5
1, 3, 5, 6
1, 3