Electrolux ESF 7530ROW User Manual page 19

Problem and alarm code Possible cause and solution
The anti-flood device is on.
The display shows
The appliance stops and
starts more times during
operation.
The program lasts too long. • Select the TimeManager option to shorten the pro-
The remaining time in the
display increases and skips
nearly to the end of pro-
gram time.
The options of the program
have to be set again every
time.
Small leak from the appli-
ance door.
The appliance door is diffi-
cult to close.
Rattling/knocking sounds
from inside the appliance.
The appliance trips the cir-
cuit-beaker.
Refer to "Before first use",
"Daily use", or "Hints and
tips" for other possible
causes.
Once you have checked the appliance,
deactivate and activate the appliance. If
• Close the water tap and contact an Authorised Service
Centre.
.
• It is normal. It provides optimal cleaning results and
energy savings.
gram time.
• If the delayed start option is set, cancel the delay set-
ting or wait for the end of the countdown.
• This is not a defect. The appliance is working correctly.
• To save your favourite configuration use option MyFa-
vourite.
• The appliance is not levelled. Loosen or tighten the ad-
justable feet (if applicable).
• The appliance door is not centred on the tub. Adjust
the rear foot (if applicable).
• The appliance is not levelled. Loosen or tighten the ad-
justable feet (if applicable).
• Parts of the tableware are protruding from the bas-
kets.
• The tableware is not properly arranged in the baskets.
Refer to basket loading leaflet.
• Make sure that the spray arms can rotate freely.
• The amperage is insufficient to supply simultaneously
all the appliances in use. Check the socket amperage
and the capacity of the meter or turn off one of the ap-
pliances in use.
• Internal electrical fault of the appliance. Contact an Au-
thorised Service Centre.
the problem occurs again, contact an
Authorised Service Centre.
For alarm codes not described in the
table, contact an Authorised Service
Centre.
ENGLISH 19