Advertisement
Convenient Function
Radio Data System (RDS)
RDS is a system performing convenient functions for FM stations in
such as Europe. However, there may be some areas where RDS is
not effective for reception.
8
Station name appears instead of the frequency.
8
The clock is automatically adjusted.
AF
Alternative frequency
8
When reception is poor, an RDS station broadcasting the same pro-
gram is tuned in automatically.
3To select AF receiving sensitivity
Press [AF]
a
☞
r)
(Attached sheet
AF1
: For mountain areas and places enclosed by high-rise
buildings or other objects that prevent radio reception.
(Default)
AF2
: For suburbs and other places free of obstructions of view.
OFF
: For the AF function inactivated.
3To change AF range
a
Hold down [AF] for 2 seconds
or more
8
REGION ON : To select a station broadcasting the same program
8
REGION OFF : To select an AF station of the same network
(The program may be different) (Default)
3AF1 or AF2 auto preset memory
8
The memory is valid for the RDS stations only.
8
A station of the same network in good receiving condition is
received.
8
If a preset station is in poor receiving condition, another station in
good receiving condition can be tuned in to by pressing the same
preset button. (Best Station Research)
☞
8
PI Seek (Attached sheet
t)
TA
Traffic Announcements
8
To automatically listen to a station that gives
traffic information periodically.
☞
(Attached sheet
y)
3To select TA mode
a
Press [TA]
(Default : TA OFF)
To cancel aPress [TA] again.
8
Notes:
8
If a selected station is in poor receiving condition, another station
giving traffic announcements will be automatically tuned in.
8
When TA ON is selected, only TP station will be searched. When TA
ON is selected, only TP station will be memorized automatically.
8
Even in CD player and CD changer modes, a station giving the traf-
fic information is automatically received.
3To listen to TA only
a
Hold down [TA] for 2 seconds
or more (in FM mode)
8
To cancel aPress [TA] again.
(Or, raise the volume with [VOL]).
☞
u)
3TA Volume Set
(Attached sheet
PTY
Program Type
8
Stations can be selected by program type,
for example, news and rock.
☞
i)
3To select mode PTY
a
Press [PTY]
(Attached sheet
8
To cancel aPress [PTY] again.
3PTY preset call
a
Press [1] to [6]
☞
8
The following program types are preset. (Attached sheet
o)
qNews wSpeech eSport rPop music tClassics yMusic
3PTY selection
q Press [
]
TUNE
[
] to select a program type below.
w Press [BAND] for automatic selection.
SPEECH
MUSIC
NEWS
AFFAIRS
INFO
SPORT
EDUCATE
DRAMA
CULTURES
SCIENCE
VARIED
POP M
ROCK M
M_O_R_ M
LIGHT M
CLASSICS
OTHER M
WEATHER
FINANCE
CHILDREN
SOCIAL A
RELIGION
PHONE IN
TRAVEL
LEISURE
JAZZ
COUNTRY
NATIONAL
OLDIES
FOLK M
DOCUMENT
3PTY preset change
q Select a program type by using PTY selection or PTY pre-
set call.
w Hold down [1] to [6] for 2 seconds or more.
Note: When there is no corresponding program type, "NO PTY" is
displayed.
3Emergency Announcement
8
An emergency announcement, if broadcast, is automatically
received.
8
This function operates in other than the radio mode, and "ALARM" flashes.
Note: Press [DISP] to switch the PTY display language to Swedish.
EON
Enhanced Other Networks
8
Traffic information of the other networks is received.
Downloaded from Caradio-Manual.com Manuals
8
Preset AF data is refreshed at all times.
How to Enjoy Music
PTY(Programme Type)/
BAND/APM(Auto Preset Memory)/
MONO/LOC(Local)
/5 (Pause)
y
<
>
TUNE
Remote Control Sensor
6 TRACK 7
Fast Forward/Fast Reverse
CD Slot
CQ-RDP153N
SRC(Source)/
1 to 6 (Preset Memory)
POWER
{
DISC
}
TA(Traffic Announcement)
MUTE/LOUD(Loudness)
AF(Alternative Frequency)/
REG(Region)
VOLUME/SEL(Select)
DISP(Display)/CT(Clock Time)
Note: Remote control unit is an option (CA-RC61EX). For details, refer to the manual of the remote
control unit.
Power on
●
Press to power on.
●
Press again and hold to power off.
Note: When first powered up, a demonstration message
appears. Press
to stop the demonstration message.
[DISP]
Enjoy music in each mode
●
Press to select a mode as follows.
Radio
CD Player
When a disc is loaded.
When a changer is connected.
CD Changer
(For CQ-RDP153/RDP143/RDP133N)
Sound Controls
■Volume Adjustment
(Setting range: 0 to 40)
Turn to adjust
■Sound Control
Press to select a mode
Turn to change each level
Volume
(0 to 40)
(–12 to +12 in 2 dB step)
Bass
(–12 to +12 in 2 dB step)
Treble
(left/right: 1 to 15)
Balance
(front/rear: 1 to 15)
Fader
Note: If no operation takes place for 5 seconds or more (2 seconds in the
volume mode), the display return to the regular mode.
■Mute
■Loudness
LOUD
Press to switch on and off.
Hold down for 2 seconds or more
●Mute the sound completely.
to switch on and off.
●Enhance bass and treble tones at low
volume.
1
Press to select a band.
■Seek tuning
2
Hold down for 0.5 seconds or more.
Eject
Tuning will automatically stop when the next station is found.
[>]: higher frequency
[<]: lower frequency
■Manual Tuning
[>]: higher frequency
[<]: lower frequency
Preset Memory
●
Up to 6 stations can be stored in each of the FM1, FM2, FM3 and AM (LW/MW) band
selections.
Press to select a band for preparation.
Radio
■
Auto Preset Memory
Hold down for 2 seconds or more.
●Automatically tune the 6 stations with good reception and save
under preset buttons [1] to [6].
●Preset stations appear for 5 seconds each.
Notes:
●
Only RDS stations will be saved at default setting (AF is ON).
●
To stop scanning, press one of the preset buttons [1] to [6].
■
Manual Preset Memory
Use seek or manual tuning to find a station.
Hold down one of the preset buttons
blinks once.
Note:
New stations overwrite existing saved stations after following this procedure.
■
Preset station calling
Press [1] to [6] to call a preset station.
Caution: Never preset stations while driving.
Only discs with the label at
right are available.
●When a disc is not loaded
Insert a disc and playback starts automatically. (Attached sheet ☞ !0 )
Disc indicator
Make sure that the disc indicator is off before loading a disc.
If the disc indicator lights, eject the disc, then load a new disc.
■Track selection and track search
CD
●Next track:
Player
●Start of current track:
●Previous track:
●Fast forward:
●Fast reverse:
Release it to resume regular CD play.
■Disc Eject
Press [
u
] to stop CD play and eject the disc.
■Pause
h/5
Press [BAND] (
) to pause. Press again to resume to playback.
●When magazine is not loaded
Insert a magazine with discs and playback starts automatically.
Changer indicator
Lights when a changer with magazine is connected.
CD
■Disc selection
Changer
●Previous disc : [
For
●Next disc
CQ-RDP153
■Track selection and track search
CQ-RDP143
CQ-RDP133N
(Refer to the CD player mode.)
Note: Not compatible with CD-RW (except when CX-DP880N is connected).
Trouble may occur while playing CD-Rs/CD-RWs. Refer to the section on "Notes
on discs (CD-R, CD-RW)"
FM1
Mono/Local Selection
FM2
FM3
Mono: Reduce noise if weak signals are received
Local: Only strong signals of stations are searched
AM (LW/MW)
for in seek tuning.
■FM broadcast
Hold down [PTY](MONO/LOCAL) for 2 seconds or more to
change the mode.
■AM(LW/MW) broadcast
Press [PTY](MONO/LOCAL) to change the mode.
FM broadcast
MONO OFF/LOCAL OFF
MONO ON/LOCAL OFF
MONO ON/LOCAL ON
Band
Frequency
MONO OFF/LOCAL ON
Preset Number
CQ-RDP153N
Display Change
Program Service Name
Frequency
[1]
to
[6]
until the display
Clock Time
Note: A station name appears when it is an RDS
station.
●
●
Available Discs
Non-available
8 cm
8 cm
8 cm
CD-RW
CD-RW
CD-RW
WMA
WMA
WMA
MP3
MP3
MP3
This unit does not support CD text display.
RANDOM
●Random play
All tracks: Press [4].
All tracks on the current disc
(changer only):
Hold down [4] for 2 seconds
or more.
[
] Press
7
[
6
] Press once
[
] Press twice
6
[
7
] Hold down
[
] Hold down
6
●Press again to cancel in each play mode.
Display Change
■CD player mode
Track Number/Playing Time
Clock Time
{
] Press
}
: [
] Press
☞
e)
(Attached sheet
AM(LW/MW)
broadcast
LOCAL OFF
LOCAL ON
PTY (MONO/LOC)
DISP
Press
(3 seconds)
DISC
REPEAT
REP
●Repeat play
R5
Current track:
Press [6].
REP
lights.
R5
lights.
Current disc
(changer only):
Hold down [6] for 2 seconds
or more.
REP
blinks.
R5
blinks.
SCAN
●10 seconds play of each track.
All tracks: Press [5].
(CD)
(Changer)
1st track on each disc
(changer only):
Hold down [5] for 2 seconds or more.
Press
■CD changer mode
Disc Number/Track Number
Playing Time
(Press)
Clock Time
(Hold down for 2 seconds
or more)
Advertisement
