When Replacing Eeprom (Memory) Ic - Sanyo DP19640 Service Manual

18.5" hdtv lcd tvhd acl

Hide thumbs Also See for DP19640:

Owner's manual (30 pages)

Service manual (54 pages)

Service manual (45 pages)

Table Of Contents

Table of Contents

CONFIRMATION OF CHECK SUM, POWER ON TOTAL HOURS AND MICON VERSION

Initial total of MEMORY IC, POWER ON total hours and MICON VERSIONcan be checked on the screen. Total hours are

displayed in 16 system of notation.

NOTE: If you set a factory initialization, the total hours is reset to "0".

Please refer to "CONFIRMATION OF INITIAL DATA" when SUM DATA is not corresponding.

1. Turn on the POWER, and set to the ALL mode.

2. Set the VOLUME to minimum.

3. Press both VOL. DOWN button on the set and Channel button (8) on the remote control for more than 2 seconds.

4. After the confirmation of each check sum, turn off the power.

NOTE: The each item value might be different according to each set.

HDMI data check sum.

Main Micon check Version.

EEPROM check Version.

Parameter check Picture Quality.

Parameter check Picture Size.

CONFIRMATION OF INITIAL DATA

If a service repair is undertaken where it has been required to change the MEMORY IC, the following steps should be taken

to ensure correct data settings while making reference to INITIAL SETTING TABLE (Attached "INITIAL DATA").

1. Turn on the POWER, and set to the ALL mode.

2. Set the VOLUME to minimum.

3. Press both VOL. DOWN button on the set and Channel button (6) on the remote control for more than 2 seconds.

ADDRESS and DATA should appear as FIG 2.

NOTE: No need to set data other position than 0200~0F79.

4. ADDRESS is now selected and should "blink". Using the UP/DOWN buton on the remote, step through the ADDRESS

until required ADDRESS to be changed is reached.

5. Press VOL.UP/DOWN button to select DATA. When DATA is selected, it will "blink".

6. Again, step through the DATA using UP/DOWN button until required DATA value has been selected.

7. Pressing VOL.UP/DOWN button will take you back to ADDRESS for further selection if necessary.

8. Repeat steps 4 to 6 until all data has been checked.

9. When satisfied correct DATA has been entered, turn POWER off (return to STANDBY MODE) to finish DATA input.

After the data input, set to the initializing of shipping.

10. Turn on the Power.

11. Set the VOLUME to minimum.

12. Press both VOL. DOWN button on the set and Channel button (1) on the remote control for more than 2 seconds.

13. After the finishing of the initializing of shipping, the unit will turn off automatically.

The unit will now have the correct DATA for the new MEMORY IC.