LG Minibeam PA1000 Owner's Manual page 4

4
SAFETY INSTRUCTIONS
Read these instructions.
Keep these instructions.
Heed all warnings.
Follow all instructions.
Indoor Installation
WARNING
Do not use the projector outside and
y
do not expose the product to any hu-
midity or water.
- Since the product is not waterproof,
this may result in a fire or electric
shock.
Do not place the projector in direct
y
sunlight or near heat sources such as
radiators, fires, stoves, etc.
- This may result in fire.
Do not place flammable materials
y
such as aerosols near the projector.
- This may result in fire.
Do not allow children to cling to or
y
climb up to the projector.
- This may cause the projector to fall,
causing injury or death.
Do not install the product in a place with
y
no ventilation (e.g., on a bookshelf or in
a closet) or on a carpet or cushion.
- This may result in fire due to the
increase in internal temperature.
Do not place the product close to
y
sources of steam, oil or oil mist, such
as humidifiers and kitchen counters.
- Failure to do so may result in fire,
electric shock, or corrosion.
Do not install the product onto a wall
y
or ceiling that is close to sources of
oil or oil mist.
- The product may be damaged and
fall, resulting in serious injury.
Do not place the projector where it
y
might be exposed to dust.
- This may result in fire.
Do not use the projector in a damp
y
place such as a bathroom where it is
likely to get wet.
- This may result in fire or electric
shock.
Do not allow a tablecloth or curtain to
y
block the air vent.
- This may result in fire due to the
increase in the internal temperature.
Ensure good ventilation around the
y
projector. The distance between the
projector and the wall should be at
least 30 cm.
- This will prevent fire due to the
increase in the internal temperature.
CAUTION
When placing the projector on a table
y
or shelf, be careful not to put it near
the edge.
- The projector could fall due to bal-
ance problems, which may cause
personal injury or damage to the
product. Make sure to use the pro-
jector cabinet or stand that fits the
projector.
When moving the projector, make
y
sure to switch it off and remove the
power plug and cords.
- The power cord may be damaged,
resulting in fire or electric shock.
Do not place the projector on an
y
unstable or vibrating surface such as
a wobbly shelf or a slope.
- It may fall and cause injury.
Be careful not to tip the projector over
y
when connecting external devices to
the projector.
- This may cause personal injury or
damage to the projector.