Table of Contents
Advertisement
Watching TV
Method 1
Using
CHAfV
on the remote control unit or on the TV.
You can change channels in several ways by pressing
AIR or CABLE
to select the antenna and then following
one of the methods below,
3, Press
CHAfV
to change the channel of the cable
box.
Method 4
1. Press INPUT,
2. Press
./OY
to select CableBox [TV], and then press
ENTER.
RECORD
@~
MENU
o~o
8-8
EO~RORN
-
FAVORITE CH -
~
VOL
CH
rzJotJ
IM
o
PAGE
• • G
.. -
•••
•••
AIR
CABLE INPUT FIJSHBACK
••••
Method 2
1, Press
FLASHBACK
to switch to the previously tuned
channel.
2, Press
FLASHBACK
again to switch back to the
currently tuned channel,
• FLASHBACK will not work if no channel has been
changed after TV is turned on,
Method 3
Using remote control buttons 0-9, •
(DOT) to select
channels for VHF/UHF/CATV/OIGITAL.
To select a 1 or 2-digit channel number
(e. g., Channel 5):
Press
5~
ENT
• When selecting a l-digit channel number, it is not
necessary to press 0 before the number.
• When you enter
0-9
only, channel selection will be made
if there is no operation for a few seconds.
To select a 3-digit channel number
(e. g., Channel 115):
Press
1~1~5
To select a 4-digit channel number
(e. g., Channel 22.1):
Press 2
~2~·
(DOT)
~
1
~
ENT
• When you enter
0-9
only, channel selection will be made
if there is no operation for a few seconds,
• If you push "0" by itself, nothing will happen.
• Complete the above steps within a few seconds.
• When you enter
0-9
and • (DOT), channel selection will
be made if there is no operation for a few seconds,
(@-32
Advertisement
Table of Contents
