Troubleshooting - Clarion rdx665dz Owner's Manual

Turn off the power, then press the OPEN button
IT]
and remove the DCP
Press the reset button for about 2 seconds with a thin
rod.
Clean the compact disc with a soft cloth.
Eject the compact disc before loading the new one.
Wipe the dirt off with a soft cloth mOistened with
cleaning alcohol.
Replace with a compact disc with no scratches.
1. Turn the unit off.
2. Remove all wires attached to the power antenna
lead. Check each wire for a possible short to
ground uSing an ohm meter.
3. Turn the unit back on.
4. Reconnect each amplifier remote wire to the
power antenna lead one by one. If the amplifiers
turn off before all wires are attached, use an
external relay to provide remote-on voltage
(excessive current required).
Replace with a fuse of the same amperage. If the
fuse blows again, consult your store of purchase.
Consult your store of purchase.
Water droplets may form on Let dry for about 1 hour with the power on.
the Internal lens when the
car IS parked
In
a humid
place.
Compact disc IS heavily
scratched or warped.
Compact disc IS dirty.
DCP or source unit
connectors are dirty.
The microprocessor has
malfunctioned due to nOise,
etc.
Power antenna lead IS
shorted to ground or
excessive current IS required
for remote-on the amplifiers
or power antenna.
Incorrect wIring.
Sound IS bad
directly after
power IS turned
on.
Compact disc Another compact disc IS
cannot be loaded. already loaded.
Nothing happens
when buttons are
pressed.
No sound output
when operating
the unit with
amplifiers or
power antenna
attached.
Power does not
turn on.
(No sound IS
produced.)
22