Dell M110 User Manual page 55

Problem
Image is out of focus
The image is stretched when
displaying a 16:9 DVD
Image is reversed
Error LED is blinking amber
TEMP LED is solid amber
TEMP LED is blinking amber If the projector fan fails, the projector will
The OSD does not appear on
the screen
The remote control is not
operating smoothly or works
only within a limited range
Downloaded From projector-manual.com DELL Manuals
(continued) (continued)
Possible Solution
Adjust the focus ring on the projector lens.
1
Ensure that the projection screen is within
2
the required distance from the projector
(3.18 ft [97 cm] to 8.48 ft [258 cm]).
The projector automatically detects the input
signal format. It will maintain the aspect ratio
of the projected image according to input
signal format with an Original setting.
If the image is still stretched, adjust the aspect
ratio in the Display Settings of the Advanced
Settings menu in the OSD.
Select Projector Settings of the Advanced
Settings from the OSD and adjust the
projector mode.
A projector fan has failed and the projector
will automatically shut down.
The projector has overheated. The display
automatically shuts down. Turn the display on
again after the projector cools down. If the
problem persists, contact Dell™.
automatically shut down. Clear the projector
mode by pressing and holding the POWER
button for 10 seconds. Please wait for about 5
minutes and try to power up again. If the
problem persists, contact Dell™.
Press the Menu button on the panel for 15
seconds to unlock the OSD. Check the Menu
Lock on page 38.
The battery may be low. Check if the LED
indication from the remote is too dim. If so,
replace with a new CR2032 battery.
Troubleshooting Your Projector 55