Instruction For Use - Philips ACT-500 Service Manual

INSTRUCTION FOR USE

controls / accessories
controls ( see figure 1 )
@ off.........................switches resume and hold off
resume................stores the last position of a cd track played
hold .....................locks all buttons
# .................opens the cd lids
remote control AY3781 ( see figure 2 )
1 p ...........................3.5 mm headphone plug to connect to headphones
socket
2 hold .....................locks all buttons
3 stop......................stops playback and switches the set off
4 5 / 6..................skips and searches forward / backward tracks
5 +/ −........................adjusts the volume
6 2; ........................switches the set on, starts playback and interrupts
playback
connecting the remote control
use only the AY 3781 remote control.
press 9 on the set twice to switch off the
1
set.
firmly connect the remote control to p on
2
the set.
3 firmly connect the headphones to the plug
on the remote control.
on the remote control keep 2; pressed for
4
1 second to switch on the set and to start playback.
5 adjust the volume and sound on the psa and your remote control.
clip magnets
wear your remote control and secure your headphone
cord with these wearable magnets.
1 check the polarity of the 2 button
magnets. insert the big button magnet
underneath your garment.
2 clip the small button magnet on your outer
garment. clip the remote control on top.
3 secure your headphone cord with the
"butterfly" magnet clip.
WARNING:
–KEEP OUT OF REACH OF SMALL
CHILDREN TO AVOID CHOKING HAZARD.
–KEEP THE MAGNETS AWAY FROM CREDIT CARDS, TAPES AND
ANY ITEMS, WHICH MAY BE SENSITIVE TO THE MAGNETS.
–USERS OF PACEMAKERS OR OTHER IMPLANTED DEVICES SHOULD
CONSULT THEIR PHYSICIAN BEFORE USING MAGNETS OR DEVICES
THAT MAY GENERATE ELECTRO-MAGNETIC INTERFERENCE.
caution
use of controls or adjustments or performance of
procedures other than herein may result in hazardous
radiation exposure or other unsafe operation.
1-3
accessories / power supply
hand strap / waist pack AY3293
wear your cd player during sport activity by securing
it to the supplied hand strap / waist pack.
1 open the strap enclosure on the back of the
hand strap / waist pack and slide the cd
player inside. make sure the headphone /
remote socket is aligned to the socket hole.
2 thread the strap.
3 position your hand and adjust the strap until
the fit is snug and comfortable.
this set complies with the radio interference requirements of the
European Community.
the model and serial numbers are located inside the cd door.
batteries (supplied or optionally available)
you can use the following batteries with this cd-player:
• alkaline batteries type AAA (LR03, UM4) or rechargeable ECO-PLUS
NiMH battery.
notes: old and new or different types of batteries should not be
combined. remove batteries if they are empty or if the player is not going to be
used for a long time.
inserting batteries
1 push to open the cd door
2 open the cd compartment and insert 2 x
AAA batteries.
battery indication
the approximate power level of your batteries
is shown in the display.(on remote control)
battery full
battery two-thirds full
battery one-third full
battery dead or empty. when the batteries
are dead or empty, the symbol
is displayed, and the beep tone
sounds repeatedly.
indicator lights up orange and beeps briefly.
indicator then turns red before player switches off.
average playing time of batteries under normal conditions
battery type
normal AAA
alkaline AAA
rechargeable ECO-PLUS NiMH battery
batteries contain chemical substances, so they should be disposed of
properly.
flashes,
esp + power save
3 hours
12 hours
10 hours