Instruction For Use (Excerpt) - Philips AZ9015 Service Manual

INSTRUCTION FOR USE (excerpt)

Programming track numbers
You can select up to 99 tracks and store them in memory in a desired sequence.
Any track can be stored more than once.
1 While playback is stopped, select a track with ∞ or §.
2 Press PROGRAM to store the track.
lights up; the track number programmed and P with the total number of
y
PROGRAM
stored tracks are displayed.
3 Select and store all desired tracks in this way.
4 Press 2; to start playback of your selected tracks.
is shown and playback starts.
y
PROGRAM
• You can review the program by pressing PROGRAM for more than 2 seconds.
The display shows all stored tracks in sequence.
y
Notes: – If you press PROGRAM and there is no track selected, SELECt is displayed.
– If you try to store more than 99 tracks, FULL is displayed.
Clearing the program
1 If necessary, press 9 to stop playback.
2 Press 9 to clear the program.
CLEAr is displayed once,
y
Notes: The program will also be cleared if you
– interrupt the power supply or
– open the CD lid.
Radio play
You can tune to any FM or MW station automatically or manually.
Stereo stations are indicated by
1 Press RADIO·BAND to switch the radio on.
2 Press RADIO·BAND if necessary repeatedly to select the desired waveband.
1, 2, 3, 4 or
y
FM FM FM FM
Tuning to radio stations automatically
1 Keep 3 or 4 pressed for at least 1 second.
The radio tunes to a station with sufficient strength and radio play starts.
y
A (for "automatic search") and the current waveband and frequency are displayed.
2 Repeat searching until you find the desired radio station.
Tuning to radio stations manually
1 Keep 3 or 4 pressed.
2 Release 3 or 4, then briefly press 3 or 4 again when you are close to the desired
frequency.
3 Briefly press 3 or 4 repeatedly until you reach the desired frequency.
Radio play starts. The current waveband and frequency are displayed.
y
• To switch from radio play to CD play press 2;.
• Press 9 to switch the radio off.
Note: In case of interferences in stereo mode press · MODE to switch to mono.
Antennas
• FM: The headphone wire is used as FM antenna.
If necessary move it for optimum reception.
• MW: The internal MW antenna is directed by turning the player.
goes off and the program is cleared.
PROGRAM
.
ST
is shown.
MW
1-4
CS 46 690