Table of Contents
Advertisement
VibroPan (vibpan)
A vibrato is an effect that modulates the pitch of the incoming signal. This will take the whole signal slightly
in and out of tune at a steady pace. The DigiTech
vibrato effect that creates a lush chorus-like sound.
Pre/Post Amp - Knob 2 determines where the effect appears in the effects chain. Turn counter-
clockwise for Pre (appears before the Distortion effect), or clockwise for Post (appears after the
Noise Gate effect).
Speed - Knob 3 adjusts how fast the signal is being modulated.
Depth - Knob 4 adjusts the amount of pitch change.
Vibrato/Pan- Knob 5 adjusts the amount of panning incorporated with the vibrato effect. When
set at 0, this effect is a standard vibrato. As the parameter is turned up, the phase difference of the
vibrato signal sent to the two channels is changed until a full stereo image is obtained at 99.
Waveform - Knob 6 selects a waveform: triang, Sine, or Square.
Unicord Uni-Vibe
TM
Based on the Unicord
®
your tone.
Pre/Post Amp - Knob 2 determines where the effect appears in the effects chain. Turn counter-
clockwise for Pre (appears before the Distortion effect), or clockwise for Post (appears after the
Noise Gate effect).
Speed - Knob 3 adjusts the rate (Speed) of the chorus modulation or spinning speaker (vibrato)
effect. Ranges from 0 to 99.
Intensity - Knob 4 controls the intensity of the effect. Ranges from 0 to 99.
Chorus/Vibrato - Knob 5 selects either the chorus or vibrato effect. Turn counter-clockwise for
Chorus, or clockwise for Vibrato.
Volume - Knob 6 adjusts the volume of the effect.
(unovib)
Uni-Vibe
pedal, Uni-Vibe adds a lush chorus or rotary speaker (vibrato) effect to
TM
VibroPan also incorporates an automatic panner with the
®
20
Advertisement
Table of Contents
