Procedure 3 Format Check - Toshiba Satellite L300D Maintenance Manual

2 Troubleshooting
create a DOS partition on drive C. Then restart the computer. If the
problem persists, go to Procedure 3.
Check 3 If drive C is listed as active in the FDISK menu, perform Check 4. If drive
C is not listed as active, return to the FDISK menu and choose the option
to set the active partition for drive C. Then restart the computer. If the
problem persists, perform Check 4.
Enter DIR C: and press the Enter key. If the following message is
Check 4
displayed, go to Procedure 3. If contents of drive C are listed on the
display, perform Check 5.
Check 5 Use the SYS command in the DOS system to install system files.
If the following message appears on the display, the system files have been
transferred to the HDD. Restart the computer. If the problem persists, go
to Procedure 3.
NOTE: If the computer is running Windows Vista Home edition and the hard disk capacity
is more than 512 MB, the FDISK program will ask if you need support for a partition
larger than 2 GB. Select Y for large partition support; however, be sure to read the
precaution regarding access by other operating systems.

Procedure 3 Format Check

The 2.5-inch HDD is formatted using the low-level format program and the FREE-DOS
FORMAT program. Using these programs, follow the steps below to format the HDD.
Check 1 Enter FORMAT C:/S/U to format the HDD and transfer system files. If
the following message appears on the display, the HDD has been formatted.
If you cannot format the HDD using the test program, go to Procedure 4.
2-12 Satellite L300D/L305D/Satellite Pro L300D/EQUIUM L300D/SATEGO L300D
Downloaded from LpManual.com Manuals
Invalid media type reading drive C
Abort, Retry, Fail?
System transferred
Format complete
2.5 2.5-inch HDD
Maintenance Manual