Toshiba 32HL83 Service Manual page 9

2. SELF DIAGNOSIS FUNCTION
1) Press "9" button on the remote control during display of adjustment menu in the service mode.
2) During diagnosis, the following displays are shown.
<SELF CHECK>
Part number of microprocessor
Operation number of protecting circuit ------"00" is normal.
When indication is other than "00", overcurrent is apt to flow, and circuit parts may possibly be dam-
aged.
BUS LINE ------"OK" is normal.
When indication shows "NG (Green: OK, Red: NG)", the BUS line may possibly be short-circuit.
BUS CONT------"OK" is normal.
When indication shows "Q uuu (Green: OK, Red: NG )", the device with the number may possibly be
damaged.
BLOCK
MAIN : Main picture display --Green indication
Main picture does not display--Red indication
SUB : Sub picture display --Green indication
Sub picture does not display--Red indication
ID number of this unit.
EEP of soft version information
Data number of OPT1 and OPT2
Software version information of host microprocessor (date indication)
DVI NO : DVI number information
DVI ERR CODE : DVI status code number
BEP SW VER : Software version information for BEP microprocessor
BEP E2P VER : Software version information for BEP E2P
Total hour of turn the TV on. (Unit: hour)
*INITIALIZATION OF SELF DIAGNOSIS DATA
1) Enter the service mode, then select any register item.
2) Press and hold the RECALL button on the remote control, then press the CHANNEL up button on the TV. The
initialization has been completed.
– 9 –