Stanley FMC626 Original Instructions Manual
  1. Manuals
  2. Brands
  3. Stanley Manuals
  4. Drill
  5. FMC626
  6. Original instructions manual

Stanley FMC626 Original Instructions Manual

Hide thumbs Also See for FMC626:

Advertisement

Table of Contents

5
3
4
2
8
1
9
7
6
www.stanley.eu
FMC626

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FMC626 and is the answer not in the manual?

Questions and answers

Related Manuals for Stanley FMC626

Summary of Contents for Stanley FMC626

  • Page 1 FMC626...
  • Page 2 ENGLISH (Original instructions)

  • Page 3: Intended Use

    ENGLISH Intended use Use of an RCD reduces the risk of electric shock. Your Stanley Fat Max FMC626 drill/screwdriver has been 3. Personal safety designed for screwdriving applications and for drilling in wood, a. Stay alert, watch what you are doing and use common metal, plastics and soft masonry.

  • Page 4: Residual Risks

    ENGLISH (Original instructions) e. Maintain power tools. Check for misalignment or Hold power tool by insulated gripping surfaces, when binding of moving parts, breakage of parts and any performing an operation where the fastener may other condition that may affect the power tools contact hidden wiring.
  • Page 5 Chargers Note: The charger will not charge a battery if the cell tempera- Use your Stanley Fat Max charger only to charge the bat- ture is below approximately 10 °C or above 40 °C. tery in the tool with which it was supplied. Other batteries The battery should be left in the charger and the charger could burst, causing personal injury and damage.

  • Page 6: Important Charging Notes

    75°F (18°- 24°C). d. If charging problems persist, take Hot/Cold Pack Delay the tool, battery pack and charger to your local Stanley Fat Max service center. The battery pack should be recharged when it fails to produce sufficient power on jobs which were easily done previously.

  • Page 7: Drilling In Wood

    (Original instructions) ENGLISH To remove battery pack keyless chuck - figure F Warning! Make certain the battery pack is removed to prevent Depress the battery release button (7) as shown in figure B and pull battery pack out of tool. tool actuation before installing or removing accessories.

  • Page 8: Troubleshooting

    Drilling in metal Use a cutting lubricant when drilling metals. The exceptions Your Stanley Fat Max tool has been designed to operate are cast iron and brass which should be drilled dry. The cutting over a long period of time with a minimum of maintenance.

  • Page 9: Ec Declaration Of Conformity

    ) <2.5 m/s , uncertainty (K) 1.5 m/s Guarantee Stanley Fat Max is confident of the quality of its products and EC declaration of conformity offers consumers a 12 month guarantee from the date of purchase. This guarantee is in addition to and in no way MACHINERY DIRECTIVE prejudices your statutory rights.
  • Page 10 ENGLISH (Original instructions)
  • Page 11 (Original instructions) ENGLISH...
  • Page 12 United Kingdom Stanley Fat Max Tel. 01753 511234 210 Bath Road Fax 01753 572112 Slough, Berkshire SL1 3YD www.stanleytools.co.uk 90633828 REV-0 02/2016...

This manual is also suitable for:

Fmc601

Table of Contents