Stanley FMC620 Instruction Manual
Hide thumbs
Also See for FMC620:
- Instruction manual (41 pages) ,
- Original instructions manual (95 pages) ,
- Manual (92 pages)
Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Stanley FMC620
Summary of Contents for Stanley FMC620
- Page 1 FMC620...
-
Page 3: Intended Use
If operating a power tool in a damp location is unavoidable, use a residual current device (RCD) protected supply. Use of an RCD reduces the risk of Your Stanley Fat Max drill/screwdriver has been designed for electric shock. screwdriving applications and for drilling in wood, metal, plastics and soft masonry. - Page 4 ENGLISH (Original instructions) d. Store idle power tools out of the reach of children and Hold power tool by insulated gripping surfaces when do not allow persons unfamiliar with the power tool or performing an operation where the cutting accessory these instructions to operate the power tool.
-
Page 5: Residual Risks
Chargers To remove the battery, push the release button (12) while Use your Stanley Fat Max charger only to charge the at the same time pulling the battery out of the receptacle. battery in the tool with which it was supplied. Other batteries could burst, causing personal injury and damage. - Page 6 ENGLISH (Original instructions) Firmly tighten the chuck by turning it (4) with one hand Re-insert the battery (7). while holding the tool with the other. If the charging indicators continues flashing red at a fast This tool is supplied with a double-ended screwdriver bit in the rate, use a different battery to determine if the charging bit holder (6).
-
Page 7: Protecting The Environment
LED work light Should you find one day that your Stanley Fat Max product The LED work light (8) is activated automatically when the needs replacement, or if it is of no further use to you, do not trigger is depressed. -
Page 8: Technical Data
Chuck capacity These products also comply with Directive Max Drilling capacity 2004/108/EC and 2011/65/EU. For more information, please Steel/wood/ contact Stanley Europe at the following address or refer to the 13/38/13 masonry back of the manual. Charger FMC690L typ. 1... - Page 9 Stanley Fat Max repair agent in the Stanley Fat Max catalogue or contact your local Stanley office at the address indicated in this manual. A list of authorised Stanley Fat Max repair agents and full details of our after sales service is available on the internet at:www.
- Page 12 United Kingdom Stanley Fat Max Tel. 01753 511234 210 Bath Road Fax 01753 572112 Slough, Berkshire SL1 3YD www.stanleytools.co.uk 90595641 REV-0 01/2013...
Need help?
Do you have a question about the FMC620 and is the answer not in the manual?
Questions and answers