Olivetti d-Color P216 Operation Manual page 53

Troubleshooting
Message
Close
rear cover
Close
top cover
Duplex disabled
Press GO
e-MPS not stored
Press GO
EF not supported
Error.Power off
F###
File not found
Press GO
Format error
Hard disk
Format error
Memory card
Hard disk err ##
Press GO
I/F occupied
ID error
Insert the same
memory card
4-8
The rear cover of the printer is open. Close the printer rear cover.
The top cover of the printer is open. Close the printer top cover.
You attempted to print with a paper size and paper type that cannot be used for
duplex printing. Press [GO] to print onto one-side of the paper only.
The e-MPS job cannot be stored because RAM disk is disabled, RAM disk size is
insufficient, hard disk is not installed, or hard disk is full. Press [GO] to print error
report.
The optional envelope feeder has been installed in this printer. The optional
envelope feeder is not supported in the model d-Color P216.
Turn the power switch off and then back on again. If this message still remains, turn
the power switch off, and contact your service representative or authorized service
center.
You have attempted to print a job that is not contained in the specified virtual
mailbox, or the specified virtual mailbox is not found.
If Auto Error Clear is set to On, printing will be automatically resumed after a preset
period of time.
The hard disk installed in the printer is not formatted, and therefore cannot be read
or written.
The memory card inserted in the printer is not formatted, and therefore cannot be
read or written. To format a memory card, follow the procedure in Using the
operation panel, section of the Advanced Operation Guide.
A hard disk error has occurred. Look at the error code given in place of ## and
refer to Storage Error Codes on page 4-11. To ignore the hard disk error, press
[GO].
This message is displayed when you attempt to use the printer's operation panel to
change the environmental settings on the interface from which data are presently
being received.
The user ID entered for a private job, or a stored job is not correct. Check the user
ID that you specified on the printer driver.
You have inserted the wrong memory card when the Insert again message
was displayed. Remove the wrong memory card from the printer's memory card
slot and insert the correct memory card. The printer again reads it from the
beginning of the data.
Corrective Action
OPERATION GUIDE