Chap. 5 - Phone/Gps; Pairing; Telephone Use; Warnings And Tips For Using The Phone - Cellular Line Interphone URBAN User Manual

CHAP. 5 - PHONE/GPS

URBAN Interphone can be connected to Bluetooth
players.
Every URBAN Interphone can be connected simultaneously to up to two Bluetooth
exception of using the three- or four-unit INTERCOM function as described in Chap. 4.3/4.4).

5.1 Pairing

Before starting use of URBAN Interphone with these devices, it is necessary to perform pairing of the
various devices. This process need only be performed once. Subsequently URBAN Interphone will auto-
matically recognise the devices previously paired and will automatically connect.
Pairing procedure
1) Activate the Bluetooth ® function on the phone/GPS/MP3 (refer to the device manual for further de-
tails).
2) With URBAN Interphone in Standby mode (BLUE LED flashing), press together the buttons
3 seconds to activate "PAIRING mode" (BLUE and RED flashing).
3) Start searching for new Bluetooth ® devices on the mobile phone / GPS / MP3 reader
4) After a few seconds the device will show "F6T". Select this option.
5) If prompted for a PIN or code, enter 0000 (four zeros).
6) The voice guide will confirm successful pairing with the message "SUCCESSFUL PAIRING, CONNECTED
TO THE PHONE". The device will go into Standby mode (blue LED flashes twice every 3 seconds).
7) If the Bluetooth device requires authorisation to access the list, provide confirmation.
®
To pair a second device, repeat the procedure from step 1).

5.2 Telephone use

As specified in section 2.8, a phone call has the highest priority than any other URBAN INTERPHONE
function. In case of receipt of a phone call use the commands shown in the following table:
Answering a call
To end a call
Voice call
Redialling last number
Quick call
® devices, such as mobile phones, GPS and MP3
devices (with the
®
+ +
In case of an incoming call, press the button
or say a word out loud (voice activated response
Chap. 3.1)
To end a call press the button or wait for the
other person to end the call.
Press to activate the voice call
Press the button until the beep (1.5 seconds)
to redial the last number.
Press the button until the second beep (3
seconds) to call the number set.

5.3 Warnings and tips for using the phone

If two different mobiles are connected at the same time, the functions "Redial last number" and "Voice
call" may only be used by the first phone connected.
An Internet connection on the mobile phone may be needed to use the "Voice call".
The "Voice call" function may not be supported by your mobile phone (refer to your device manual for
further details).

5.4 GPS

After pairing the URBAN Interphone to the GPS (Chap. 5.1) it is possible to hear the voice prompts sent
by the navigator. During the intercom communication the GPS (if fitted) will interrupt the conversation
whenever it is necessary to transmit a voice prompt.
for
Attention: ensure the GPS is compatible with the Bluetooth
manual for further information.
URBAN Interphone uses the Bluetooth
Navigators integrated within smartphones use the A2DP profile to send route directions. This profile
does not allow interruption of the intercom conversation.
Navigators sold for use in cars are NOT usually equipped with Bluetooth
cannot transmit voice prompts to Bluetooth
mation.
headsets. Consult the GPS user
®
HFP profile to manage the connection to a GPS unit.
®
HFP. For that reason they
®
headsets. Consult the GPS user manual for further infor-
®
7