Configuration - AMX vision2 V8.4 Instruction Manual

Click Refresh to update the graph to see the latest readings. Use the white bar at the bottom of the page under the graph to pan
over and zoom into the selected data range as follows:
Click and drag the bar left or right to pan.

Click and drag the edges of the bar left or right to zoom in or out as required (FIG. 54).

Zooming in on a Region of the VoD Bandwidth Graph
FIG. 54
A red line appears on the upper server report graph which indicates the VOD bandwidth limit set by the VOD bandwidth license
configured on that server. This allows you to see if you are exceeding that limit.
Conf iguration
The configuration tab is used to select which network interface card to monitor on each server. The table contains a list of the
servers in your Vision2 system and a selected NIC column. Use the drop down icon in the selected NIC column to choose the IP
address of the network interface card to monitor on that server.
Configuring the Network Interface Card to Monitor on Each Server
FIG. 55
2
Vision Instruction Manual
Drag to zoom
Drag bar to pan
Manage System
39