Play Audio From Tv Or Other Devices; Play From An Mp3 Player; Play From An Ipod Or Iphone - Philips hts5120 User Manual

Note
•
The home theater can store up to 40 radio
stations.
•
Press to stop the installation.
•
AM and digital radio are not supported.
•
If no stereo signal is detected, or if fewer than
five stations are found, you are prompted to
install the radio stations again.
•
For the best reception, place the antenna away
from the TV or other sources of radiation.
Change tuning grid
In some countries, you can switch the FM tuning
grid between 50 kHz and 100 kHz. Changing
tuning grid erases all preset radio stations.
1
Press RADIO.
2
Press .
3
Press and hold
or 'GRID 10' (100 kHz) is displayed.
Play audio from TV or other
devices
Press AUDIO SOURCE repeatedly to select
the audio output of the connected device (see
'Connect audio from TV or other devices' on
page 8).

Play from an MP3 player

Connect and play audio files from an MP3 player
or other external audio devices.
1
Connect the MP3 player to the home
theater.
2
Press AUDIO SOURCE repeatedly until
'MP3 LINK' appears on the display panel.
3
Press the buttons on the MP3 player to
select and play audio files.

Play from an iPod or iPhone

By connecting and installing a Philips Dock for
iPod/iPhone, you can use the home theater to
play music, movies and photos from your iPod or
iPhone.
until 'GRID 9' (50 kHz)
Note
•
Philips Dock for iPod/iPhone is sold separately.
•
You can charge your iPod/iPhone on the dock
while the home theater is in iPod mode.
Dock your iPod or iPhone
1
Connect the dock to the home theater and
connect the yellow composite cable from
the dock to the TV. For more information,
see the Quick Start provided with the dock.
2
Switch on the iPod or iPhone and place it in
the dock.
Listen to music
1
Dock your iPod or iPhone (see 'Dock your
iPod or iPhone' on page 13).
2
Press DOCK for iPod on the home theater
remote control.
3
Browse on the iPod or iPhone screen to
select track.
4
Press OK to play the track.
Watch video or view slideshows
Note
•
On iPod, enable the TV ON setting.
•
On iPhone, select the TV Out option.
1
Dock your iPod or iPhone (see 'Dock your
iPod or iPhone' on page 13).
2
Press DOCK for iPod on the home theater
remote control.
3
Switch the TV to the AV/VIDEO source
(corresponding to the yellow composite
cable).
The TV screen goes blank.
»
4
Browse on the iPod or iPhone screen to
select videos or photos.
5
Press OK on the home theater remote
control or PLAY on the iPod/iPhone to play
the video or photos.
The picture is displayed on the TV.
»
EN
13