Advertisement
Congratulations on your purchase of the Legacy Aviation 65" Turbo Duster optional float
set!
Items needed for completion:
Hobby knife with #11 blades.
Blue Loctite.
Silicone lubricant
Electric drill with an assortment of small drill bits.
Small flat head and Phillips head screw drivers.
Standard and needle nose pliers.
Side cutter.
Metric ball driver or allen key set.
1 x METAL GEARED servos with a minimum of 76oz of torque. All flight testing
was performed with Hitec HS-5245MG.
2 x 12" servo extensions
Clear packing tape.
Small ZIP ties
Clear latex or silicone caulk.
Let's begin!
1. If you are converting from land use, remove the main landing gear and tailwheel
from your aircraft. Support the fuselage upside-down on your building table. Remove
the covering over the rear float mounts on the fuselage as shown.
3
Advertisement
