Oki C8600 User Manual page 75

USB
MENU
This menu controls the operation of the printer's USB data
interface.
I
TEM
SOFT RESET
SERIAL NUMBER
SPEED
NOTE:
When you have changed any settings in the USB MENU, turn
the printer OFF, then ON again.
N
ETWORK MENU
This menu controls the operation of the printer's 10Base-T/
100Base-TX network interface.
I
TEM
TCP/IP
NETBEUI
IP ADDRESS SET
IP ADDRESS
SUBNET MASK
GATEWAY
ADDRESS
FACTORY
DEFAULTS
WEB
TELNET
S
ETTINGS
ENABLE /
DISABLE
ENABLE /
DISABLE
12 / 480 Mps
S
ETTINGS
ENABLE /
DISABLE
ENABLE /
DISABLE
AUTO / MANUAL
xxx.xxx.xxx.xxx
xxx.xxx.xxx.xxx
xxx.xxx.xxx.xxx
EXECUTE
ENABLE /
DISABLE
ENABLE /
DISABLE
Menu functions> 75
E
XPLANATION
Enables or disables the SOFT RESET
command.
Specifies whether to ENABLE or DISABLE
a USB serial number.
The USB serial number is used to identify
the USB device connected to your PC.
Selects the interface speed
E
XPLANATION
Enables or disables this network protocol.
Enables or disables this network protocol.
Specifies whether IP address allocation is
automatic (DHCP) or manually assigned.
Current assigned IP address. To change,
press ENTER and use +/– buttons to
increment 1st octet, then press ENTER
again to move on to next octet. When 4th
octet has been set, press ENTER again to
register new address.
Current assigned subnet mask. To
change, proceed as above.
Current assigned gateway address. To
change, proceed as above.
Reloads the settings present when the
unit was setup by the manufacturer.
Enables or disables Web config. facility.
Enables or disables Telnet config. facility.