Table of Contents
Advertisement
There is something wrong
with the TV.
There are small particles
on the TV's bezel.
The PIP menu is not
available.
A POP (TV's internal
banner ad) appears on
the screen.
The TV is making a
popping noise.
The TV is making a
humming noise.
Schedule Recording/Time Shift
There is something
wrong with the TV.
The TV cannot
recognize the USB
device or failing
Device
Format,
Check
Device, and
Device
Performance
Test.
There is a message
saying I need to
format the USB
storage device.
Schedule Recording
cannot be used.
I get a performance
test failure message
Schedule
and then
Recording
and the
Time Shift operation
stops working.
This is part of the product's design and is not a defect.
PIP
functionality is only available when you are using an HDMI or Component
source.
Use Mode (Support
Change
The expansion and contraction of the TV's outer casing may cause a popping
noise. This does not indicate a product malfunction. The TV is safe to use.
This TV utilizes high-speed switching circuits and high levels of electrical
current, and depending on the brightness level being used may seem slightly
noisier than a conventional TV.
This TV has undergone strict quality control procedures that meet our demanding
performance and reliability requirements.
Some noise coming from the TV is considered normal and is not an acceptable
cause for an exchange or refund.
Refer to the USB device's manual and see if data can be stored on it.
Check if the USB device is in a locked state.
Check if the USB device was formatted when it was connected to a computer.
Formatting a USB device after connecting it to the TV may result in a formatting
Device Performance Test
failure. If
problem with the USB device or its specifications. Try using a different USB device.
Check if the USB device is in a locked state.
Use the USB recovery function to recover the USB device.
Check if there is a USB device connected to the TV.
Check if the channel is a digital channel that can be recorded. Recording will
automatically stop if the signal becomes too weak. The Time Shift function will not
work if there isn't enough storage space on the USB device.
This problem can occur when using a low-performance USB storage device that
does not support recording. A USB hard drive with a speed of 5,400rpm or above
is recommended. However, RAID-type USB hard drives are not supported.
Try this!
Use
Mode) to
Home
>
Try this!
Device Format
or
Use.
has failed, there may be a
Advertisement
Table of Contents
