PAGE Introduction ....................4 carefully through this Owner’s Manual. General Design ....................5 The Supersport™ is an inflatable sailboat that converts easily for Certification ....................3 optional use as a windsurfer. Compared to other sailboats, the Safety ......................3 Supersport™ is lightweight, compact and very portable.
Supersport Owner’s Manual ™ Table: Design Data C. Certification Model Name Supersport™ Supersport™ Brand Name Your vessel is inspected and certified by: Aquaglide® Aquaglide® Type of craft Inflatable Boat Inflatable Boat Design category Maximum users Hull form Monohull Monohull Construction material...
3,10m2 3,10m2 Mast Height 3,50m 138” Both shape and weight affect the stability of your Supersport™ Inflatable Boom Length 1,45m 57” Boat. The shape is determined by the manufacturer, and cannot be changed. The total weight is determined by the weight of the empty Supersport™...
Each person should use a harness strap • Maximum number of users: 2. to carry the vessel. Lift the Supersport™ from the water and set it down carefully on soft grass or similar ground for drying and disassembly. In...
A PVC-safe antifouling paint should be used to help protect this product against marine growth. DAMAGE CAUSED BY EXPOSURE TO SALT WATER IS NOT COVERED BY WARRANTY. www.Aquaglide.com North Sports, Inc. #1 North Shore Dr, SE White Salmon, WA 98672 TEL: (509) 493-4938...
Supersport Owner’s Manual ™ II. Package Contents Before attempting to assemble, locate and familiarize yourself with each of the components included with your Supersport™. A. Included Items Tiller Handle Rudder Keel (2 pcs) Roller Travel Bag Sailing Harness Main Sheet/ Uphaul Strap...
NOTE: Dragging or sliding the WARNING: Do not use an air compressor to inflate tube. Air Supersport™ over the ground either before or after inflation can cause compressors can cause tube to burst if over-inflated. DO NOT EXCEED damage.
You will need to assemble 3 rope extensions for the current 3x pieces shroud system of the Supersport. This allows enough length of the straps to adapt to the Supersport hull 1) Cut 3 pieces of line to 85cm. Make sure to burn the ends of the rope 2) Fold the rope in half so that it is 42.5cm...
Installing the Shroud Lines and rope extensions The shroud lines and Bridles attach the sailboat rig to the hull and must be carefully installed. Because the Supersport is able to accept several differrent sizes of sails, the rope loop extensions must be used for the larger sails.
Supersport Owner’s Manual ™ Preparing the side bridle straps The bridle straps consist of a rope and buckle, a webbing strap with a looped end and the rope extension loops shown on the previous page. It should look as shown on the right when assembled.
Multisport™ 270. Roll out the sail on a soft, flat surface. A grassy area or the Supersport™ hull itself works well. If it’s windy, try to pick a sheltered area, as the sail will catch wind immediately.
(Tip: the round hole above the 34cm mark should be aligned with the plastic groove on the lock) 7. Extend the boom to 34cm on the adjustment arm. www.Aquaglide.com North Sports, Inc. #1 North Shore Dr, SE White Salmon, WA 98672 TEL: (509) 493-4938...
11. With the boom clamp open, pry the grip section open enough to insert the mast. The grip section is designed to flex enough to accommodate the mast. www.Aquaglide.com North Sports, Inc. #1 North Shore Dr, SE White Salmon, WA 98672 TEL: (509) 493-4938...
B-14 Cleat 16. Engage the line in the embedded cleat as shown in B14. www.Aquaglide.com North Sports, Inc. #1 North Shore Dr, SE White Salmon, WA 98672 TEL: (509) 493-4938 FAX: (509) 493-4966...
2. Lay the board on it’s side and insert the rig into mast mast foot pin lock. 3. Lay the rig on it’s side as shown. www.Aquaglide.com North Sports, Inc. #1 North Shore Dr, SE White Salmon, WA 98672 TEL: (509) 493-4938...
Supersport Owner’s Manual ™ Attaching the Rig with the sailing harness Sailing Harness Pull Rig Up Lines should be loose Figure: 2 Figure: 1 Padeye Mast Clip Mast Clip Forestay (center) Pull Shroud Shroud 1. Make sure all webbing adjustments are loose on all 3 attachment Tighten points.
Once in position, remove the Fin Screw, leaving only the Fin Tab in position at the front of the Fin Box. www.Aquaglide.com North Sports, Inc. #1 North Shore Dr, SE White Salmon, WA 98672 TEL: (509) 493-4938...
Page 19
2. IMPORTANT: Before using the product, be sure to read and understand the Warnings on page 5-6. 3. IMPORTANT: When moving the Supersport™, always lift and set it down. DO NOT DRAG, as this can damage the product before you get started.
Using the Supersport as a Windsurfer WINDSURFING MODE It’s easy to switch from sailing mode to windsurfing mode. Just remove the rear Aft Position Forward Position rudder, move the fin back, remove the shrouds, and move the main sheet from the back to the front.
Supersport Owner’s Manual ™ C. Move the main sheet from the back of the boom to the front to be used as an uphaul. 1) Remove main sheet by removing the knot at the boom end. 2) Remove the webbing attachment on the bottom from the board.
This allows users to focus on steering. Tension the main sheet strap as needed, tightening for better upwind 1. To operate the Supersport™ it is only necessary to have 1 person sailing, loosening to improve speed and downwind sailing angles.
6. Long-term exposure to sunlight will damage the product. The best way to care for your Supersport™ is to store it dry and out of the sun. 9. When windsurfing, it is not uncommon to loose your balance and fall in the water.
Fold 2 - Mast Step Finbox. Fold toward the back and Finbox 5. Once disassembled, follow the steps below to pack the Supersport™ as shown in Photo 9. in the roller travel bag for storage or transport. 6. Rolling the sail. The Sport™ sail should be rolled up for storage.
North Sports, Inc. and Aquaglide from any and all liability for any loss, damage, injury, or expense that you or any users of this product may suffer, or that your next of kin may suffer, as a result of the use of this product, due to any cause whatsoever, including negligence or breach of contract on the part of North Sports Inc. and Aquaglide in the design or manufacture of this product and any of its components.
PVC. Apply a thin, even layer of glue to both the patch and the bladder. Most contact glues require that you The Supersport™ comes with a small repair kit that is sufficient to fix allow them to dry somewhat BEFORE you apply the patch. Carefully most small punctures.
Page 29
Declaration of Conformity The following Declaration of Conformity is issued under the sole responsibility of the manufacturer. Product Item Number 58-5216658 Multisport 270 58-5215060 Superport Description: The product(s) described above are constructed primarily of reinforced polyvinylchloride (PVC) and polyester fabrics. The product(s) is an inflatable multi-purpose watercraft designed to be used in sheltered waters for the purpose of sport and recreation.
Need help?
Do you have a question about the Supersport and is the answer not in the manual?
Questions and answers