Page 1
Advanced Ceramic MOV technology reduces risk of fire from surges. Surge Disconnect In the event of a catastrophic surge event, this WattBox™ component will sacrifice itself and permanently disconnect AC Power. Noise Filtration Eliminates AC noise to improve picture and sound quality.
REQUIRED WIRING We recommend the use of 12/2C or 14/2C IN-DOOR building electrical wire to connect to the WB-200-IW-2. All wiring should be performed by a licensed electrician . Verify with your electrician that the building electrical wire run to the location of the WB- 200-IW-2 meets or exceeds 12/2C or 14/2C IN-DOOR.
3. Verify that the AC circuit to the location is OFF. 4. Strip 1/4 -inch off each of the three ROMEX® wires and three wires on the rear of the WB-200-IW-2. 5. Using wire nuts, connect the three electrical wires to the WB-200-IW-2.
• Do not attempt to service the WB-200-IW-2. Refer all servicing to qualified service personnel. Servicing is required when the WB-200-IW-2 has been damaged in any way, such as being exposed to rain or moisture, or LEDs do not illuminate when connected to main electrical service.
WB-200-IW-2-WHT Installation and Users Manual TROUBLESHOOTING Symptom Possible Cause Remedy No power to devices plugged WB-200-IW-2 is not receiving power. Verify that the circuit breaker on electrical • into the WB-200-IW-2. panel has not been tripped and is ON. Check the in wall airing for proper connec- •...
WB-200-IW-2-WHT Installation and Users Manual SPECIFICATIONS Outlets Type NEMA 5-15 Number of Outlets AC Power Line Voltage 120V, 60Hz UL Current Rating Voltage Protection Rating (UL 1449 3rd Edition) 500V Joule Rating 1080 Joules Surge Component Ceramic Encased MOV Protection Modes...
WB-200-IW-2-WHT Installation and Users Manual WARRANTY SnapAV Surge Protector Lifetime Product Warranty SnapAV warrants to the purchaser of any standard SnapAV surge protector that the surge protector shall be free of defects in design, material, or workmanship, and SnapAV will repair or replace any defective unit. For product replacement, see “NOTIFICATION”...