Advertisement
THE WINDMILL CEILING FAN
INSTALLATION INSTRUCTIONS
Please read and save these instructions
These instructions are to be used in
the installation of the following
QUORUM INTERNATIONAL fans...
The Windmill
© 2015 Quorum International. All Rights Reserved.
P.O. Box 961008 • Fort Worth, TX 76161 • (817) 626-5483 • FAX (817) 626-5540
I0230-10/15
Advertisement
Table of Contents
Related Manuals for QUORUM INTERNATIONAL The Windmill
Summary of Contents for QUORUM INTERNATIONAL The Windmill
-
Page 1: Installation Instructions
These instructions are to be used in the installation of the following QUORUM INTERNATIONAL fans... The Windmill © 2015 Quorum International. All Rights Reserved. P.O. Box 961008 • Fort Worth, TX 76161 • (817) 626-5483 • FAX (817) 626-5540 I0230-10/15... -
Page 2: Warranty & Service
QUORUM'S UNIQUE LIMITED LIFETIME WARRANTY This warranty gives you specific legal technical skill, competence, or experience superior product if the defective unit is of the user. rights, and you may also have other rights returned prepaid to us. which vary from state to state. 8. -
Page 3: Safety Rules
1. SAFETY RULES Model #96015-xx: 37.5 lbs 97215-xx: 44.6 lbs 1. To avoid possible electric shock, turn 5. To reduce the risk of fire, electric 9. To operate the reverse function on the off the electricity at the main fuse box or shock, or other personal injury, mount fan fan, press the reverse button on the wall circuit panel before you begin the fan... -
Page 4: Mounting Options
3. MOUNTING OPTIONS 1. Disconnect the power by removing fuses or turning off circuit breakers. Fig. 1 Ceiling Joists 2. If there is an existing outlet box, ensure it is clearly marked "Suitable for Fan Support of 50 lbs (22.7 kg) or lesse". If it is not so marked, it must be replaced with an approved one. -
Page 5: Attaching The Fan Blades
5. ATTACHING THE FAN BLADES WARNING -Turn off the power! Fig. 5 Fig. 7 NOTE: Please see the label of the blade side up as illustration shown for assembly. Blade deco bar Fan blade screws (Screw No. 1) 1. Slide the blade deco plate to position Blade deco bar Hole the blade hole on the center of the blade. - Page 6 6. ATTACHING THE BLADE ARMS WARNING -Turn off the power! Fig. 9 1. Carefully lift the blade circle to the fan assembly. (Fig. 9) Important assembly process, it is a must to require 3 persons at least to lift the blade circle evenly onto the fan body and positioning the blade holes at inner circle.
-
Page 7: Electrical Connections
7. ELECTRICAL CONNECTIONS REMEMBER -Turn off the power! Use the wire nuts supplied with your fan If your junction box has a ground Use ONLY wall controls approved by when making connections. Secure the wire (green or bare copper), connect Quorum. - Page 8 8. COMPLETING INSTALLATION 1. Make sure the wiring is safely inside the Fig. 15 Fig. 17 outlet box as instructed in Step 5 - Electrical Connections. To install the Outlet box canopy, slide the canopy up to hanger bracket and place the key hole on the canopy over the screw on the hanger Hanger bracket...
-
Page 9: Installing The Wall Control
9. INSTALLING THE WALL CONTROL REMEMBER -Turn off the power! Fig. 18 3. (Fig. 18) Carefully tuck the wire Hook up in "series only" do not connect connections inside the junction box. the hot and neutral wires of electric Secure the wall control with the two circuit to the transmitter wall switch - screws provided. - Page 10 11. FAN OPERATION AND CARE 1. A ceiling fan is an environmentally 3. Clean you fan periodically using only Fig. 21 smart choice to cool as well as to help a cloth dampened with a mild detergent warm your home or office. Adjust your solution for all hardware - never use HVAC thermostat during fan use to save solvents.
-
Page 11: Troubleshooting
12. TROUBLESHOOTING FAN WILL NOT START 3. Use of a standard light rheostat or an EXCESSIVE WOBBLE 1. Check that the electricity has been Note: A small amount of wobble is unapproved fan wall control to control the turned on at the circuit breaker which had fan speed will always cause an annoying considered acceptable and should not be probably been turned off during...
Need help?
Do you have a question about the The Windmill and is the answer not in the manual?
Questions and answers