Advertisement
INTELLIGENT CLEANER
OPERATING MANUAL
After the introduction of the Intelligent Cleaner,
please note the following operating procedures:
1. Please ensure the battery is fully charged before starting the Cleaner.
2. Please tidy unfixed articles on the floor before using the Cleaner, and keep it from the
spikes at edge of carpet and power lines, etc. on the floor as possible.
3. Turn on its main power start button, there are three start buttons: Spot, Clean and Max,
representing three different cleaning modes. In addition, there is a timing work mode:
A. Spot mode(S):
B. Clean mode(M):
C. Max mode(L):
D. Timing mode:
4. If you don't want your Cleaner to clean those areas beyond your desired cleaning area,
please place the Virtual Wall Unit at the proper place such as the following illustration:
The Cleaner can make repeated screw type cleaning within the
scope of 3 feet of diameter, focusing to clean a spot for 4 minutes.
It's applicable for cleaning the room where is dirty at partial places.
The Cleaner will automatically clean the room for 30 minutes. The
mode is applicable for cleaning small room.
The Cleaner won't stop running until complete consumption of is
power. The working time is excess 60 minutes.If the auto charging
base plate is used, the Cleaner will automatically return to it for
charging.
The cleaning time can be set by the time setting key on the charg-
ing base plate. The Cleaner will leave the auto charging base plate
to work as per the pre-set time and the cleaning time is 60 minutes,
and then it will automatically return to the socket for charging (refer
to the Article of Charging for the detailed method).
It's better to put the Virtual
Wall Unit behind the door.
- 4 -
Infrared ray
Advertisement
