Advertisement
INTELLIGENT CLEANER
OPERATING MANUAL
The cleaner can be controlled to clean by the infrared remote controller. As the above
drawing, three keys: Spot, Clean and Max is respectively for three work modes. By direc-
tion key, it can operate the Cleaner to work in different directions. The P key is for power-
ing on/off. Press the P key, the indicator on the panel will be off and the Cleaner enter
Sleep mode, which enable to save energy maximally in non-operating state. Press again
the P key on the panel, the indicator will be on, and the unit will enter the Standby stage,
waiting for the next command.
When the Virtual Wall and remote controller are used in the same area, as they all use
the infrared signal, which may lead to temporary failure for the remote controller, you may
operate the remote controller after turning off the Virtual Wall or the unit being far from the
Virtual Wall.
Intelligent cleaner is user-friendly very little maintenance required after use to ensure
optimal performance please observe the following procedures:
Empty the removable particle bin in following two
procedures:
1. Empty the bin
a. Turn off the power switch.
b. Press down the bin clip and pull out the bin as following illustrations:
c. Clear the bin.
d. In inserting the bin, press the clip on the bin for facilitating inserting.
2. Clean the filter mesh
a. Turn the bin upside down.
b. Press the bottom slightly, take the filter mesh out as following drawing:
- 10 -
Advertisement
