JVC GR-AXM17US Service Manual page 15

3.2.4 ASSEMBLY/DISASSEMBLY OF [8] MONITOR ASSEMBLY
Disassembly of MONITOR ASSEMBLY
NOTE :
Be careful not to soil or scratch the monitor screen through
the disassembly/assembly work.
(1) While removing the three screws 1 to 3 in numerical
order and disengaging the four hooks (L8a and L8b) in
alphabetical order, remove the MONITOR COVER
ASSEMBLY.
NOTE 8a :
After removing the MONITOR COVER ASSEMBLY,
be careful not to damage the FPC and the connector
because the MONI. HINGE ASSEMBLY moves
very easily.
(2) Unlock the connector 8a and then remove the FPC
while lifting the MONI. HINGE ASSEMBLY upwards to
remove it together with the FPC.
NOTE 8b :
When removing the FPC, unlock the connector first
and then lift the MONI. HINGE ASSEMBLY up-
wards. Accordingly, the FPC is removed together
with the MONI.HINGE ASSEMBLY.
(3) Unsolder the two soldered parts (SD8).
NOTE 8c :
When removing the MONITOR BOARD ASSEM-
BLY and the BACKLIGHT together, it is not neces-
sary to unsolder the two soldered parts (SD8).
(4) Unlock the connector 8b, and disconnect the FPC
from the connector 8b.
(5) Disconnect the FPC from MONITOR CASE ASSEM-
BLY.
(6) Remove the screw (4), and remove the MONITOR
BOARD ASSEMBLY while lifting the side of MONI-
TOR BOARD ASSEMBLY which has been attached
with screw (4) upwards.
(7) Remove the BACKLIGHT and DIFF. SHEET (2.5) in
this order.
(8) Remove the FRARE (LCD), the SPRING (LCD), and
the LCD MODULE all together.
NOTE8d:
As the SPRING (LCD) and the LCD MODULE are
attached to the FRAME (LCD), remove them all to-
gether for the parts exchange.
(9) Remove the S. CASE (2.5) by removing the two hooks
(L8f, L8g) in order.
L8a
MONITOR COVER
ASSY
NOTE8a
NOTE8b
CN8a
MONITOR
BOARD ASSY
a
FPC
c
NOTE8a
MONI. HINGE
ASSY
a
L8f
MONITOR CASE
ASSY
2
(S8b)
Fig.3-2-4
L8b
L8c
L8d
NOTE8b
(S8a)
CN8b
4
(S8c)
b
SD8
BACKLIGHT
ASSY
NOTE8c
DIFF.SHEET(2.5)
NOTE8d
FRAME(LCD)
LCD MODULE
LEAD SIDE
b
SPRING
(LCD)
L8e
S.CASE(2.5)
L8g
c
L8h
3
: 0.098N . m (1.0kgf . cm)
(S8b)
(No.YF073)1-15
1