JVC GR-AXM17US Service Manual page 12

3.2.3 ASSEMBLY/DISASSEMBLY OF [5] VF ASSEMBLY
Prior to disassembly
VF ASSEMBLY mainly consists of two CABINET PARTS (UP-
PER CASE (VF)/ BOTTOM CASE (VF)), and LCD SA/LENS
SA inside.
As LCD SA and LENS SA are each consist of several parts,
disassemble as required during the procedure.
1-12 (No.YF073)
Disassembly procedure
STEP
Fig.
PART NAME
No.
No.
[1] UPPER CASE(VF) VF1,2
/BOTTOM CASE(VF)
[2] VF BRACKET ASSY VF3
[3] LENS SA/LCD SA VF4
/BWVF BOARD ASSY
[4] LENS SA VF5
[5] LCD SA
NOTE 5a :
Follow the wiring of the LCD MODULE FPC as shown in the
Fig.VF1, and be sure to place the FPC within the BOTTOM
CASE.
NOTE 5b :
Place the SUPPORT PLATE inside the BOTTOM CASE.
NOTE 5c :
Refer to the Fig. VF5 for the LENS SA disassembly.
NOTE 5d :
Refer to the Fig. VF5 for the LCD SA disassembly.
NOTE 5e :
During the procedure, be careful in handling the parts.
NOTE 5f :
When attaching the LEVER VF, be careful in positioning with
the LENS ASSY.
Attach the LEVER VF by pulling the LENS ASSY to the EYE
CUP side.
After the attachment, check whether the slide operation is
smooth.
NOTE 5g :
When disassembling, be sure not to lose any parts.
POINT NOTE
2(S5a),2(S5b),2(L5a),2(L5b) NOTE5a,b
2(S5c) -
L5c,d,CN5a,2(L5e),2(L5f) NOTE5c,d
L5g,L5h,L5j NOTE5e,f,g
L5k,L5m,L5n,L5p NOTE5e