Technical Specifications - McAfee 1650 Hardware Manual

Technical specifications

McAfee DLP appliances meet all safety and operational standards and are in compliance with FCC
standards.
McAfee DLP rack mounting requirements
McAfee DLP hardware must be rack mounted properly to ensure safe configuration.
This checklist provides requirements for installing McAfee DLP hardware in a rack.
• Elevated operating ambient temperature — If installed in a closed or multi-unit rack assembly,
the operating ambient temperature of the rack environment might be greater than room ambient.
Consider installing the equipment in an environment compatible with the maximum ambient
temperature (MAT) specified by the manufacturer.
• Reduced air flow — When installing the equipment in a rack, do not compromise the amount of
air flow required for safe operation.
• Mechanical loading — When mounting the equipment, make sure no hazardous conditions are
created due to uneven mechanical loading.
• Circuit overloading — When connecting the equipment to the supply circuit, consider the effect
that circuit overloading might have on overcurrent protection and supply wiring. Use appropriate
consideration of equipment nameplate ratings when addressing this concern.
• Reliable earthing — Maintain reliable earthing of rack-mounted equipment. Give particular
attention to supply connections that are not directly connected to the branch circuit, such as power
strips.
McAfee DLP power redundancy
McAfee DLP appliances with more than one power supply must be configured to provide redundancy
by sharing the load while operating at nominal power. Additional protection is provided if two electrical
outlets that are on different circuit breakers are used.
If one power supply fails, a backup fan automatically turns on, an alarm sounds, and a warning LED
illuminates. If a power supply fails, contact McAfee for a replacement unit.
McAfee DLP FCC compliance
McAfee DLP hardware has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 16 of the Federal Communications Commission rules. Any modifications to McAfee
DLP equipment, unless expressly approved by the party responsible for compliance, could void
authority to operate the equipment.
Operation of the McAfee DLP appliances is subject to the following conditions:
• The device might cause harmful interference, and
• The device must accept any interference received, including interference that might cause
unwanted operation.
These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment.
14
If a McAfee DLP appliance loses power for any reason, the appliance will not come back up unless you
change the BIOS setting in advance. The motherboard is set to off by default.