Table of Contents
Advertisement
Anynet+ (HDMI-CEC)
There is something
wrong with the TV.
Anynet+ does not
work.
I want to start
Anynet+.
I want to exit Anynet+.
The message
"Connecting to
Anynet+ device..."
or "Disconnecting
from Anynet+ device"
appears on the screen.
The Anynet+ device
won't play.
The connected device
is not displayed.
The TV audio is not
being played through
the receiver.
Check if the device is an Anynet+ device. The Anynet+ system supports Anynet+
devices only.
Only one external device may be connected to Receiver.
Check if the power cord of the Anynet+ device is properly connected.
Check the cable connections of the Anynet+ device.
System
Navigate to the
Check whether the TV remote control is in TV mode.
Check whether the remote control is Anynet+ compatible.
Anynet+ may not function under certain circumstances. (Searching channels,
operating Smart Hub or Setup, etc.)
If you have disconnected and then reconnected the HDMI cable, scan for devices
again or turn your TV off and on.
Check if the Anynet+ device is properly connected to the TV and then navigate to
System
the
menu to see if
After checking, select the Virtual Remote panel's or the regular remote's
buttonn to display the list. Select
View TV
Select
from the Anynet+ menu.
Select a non-Anynet+ device from Source.
You cannot use the remote control when you are configuring Anynet+ or switching
to a viewing mode. Use the remote control after the TV has completed the Anynet+
configuration or has switched to a viewing mode.
You cannot use the play function when
Check whether the device supports Anynet+.
Check whether the HDMI cable is properly connected.
System
Navigate to the
Scan for Anynet+ devices again.
Anynet+ devices must be connected to the TV using an HDMI cable. Make sure the
device is connected to your TV with an HDMI cable. Some HDMI cables may not
support Anynet+.
If the connection is terminated because there has been a power failure or the HDMI
cable has been disconnected, please scan for the device again.
Connect an optical cable to the TV and the receiver.
ARC enables digital sound to be output via the HDMI (ARC) port.
However, ARC is only available when the TV is connected to an audio receiver that
supports ARC.
Try this!
Anynet+ (HDMI-CEC)
menu and verify that
Anynet+ (HDMI-CEC)
Anynet+ (HDMI-CEC)
Setup
Anynet+ (HDMI-CEC)
menu and verify that
is set to On.
is set to On.
from the list.
is progress.
is set to On.
TOOLS
Advertisement
Table of Contents
