Turning The Camera On And Off - Nikon COOLPIX L810 Reference Manual

Turning the Camera On and Off

• Remove the lens cap and turn the camera on.
• When the camera is turned on, the power-on lamp (green) will light and then the monitor
will turn on (the power-on lamp turns off when the monitor turns on).
• To turn off the camera, press the power switch. When the camera turns off, the power-on
lamp and the monitor turn off.
• You can press and hold the c (playback) button to turn on the camera and switch to
playback mode. The lens will not extend.
B
If Turn the camera off, remove the lens cap, and turn the camera on. Is Displayed
Make sure that the lens cap has been removed, and turn the camera off and then on again.
C
Power Saving Function (Auto Off)
If no operations are performed for a while, the monitor will turn off, the camera will enter standby
mode, and the power-on lamp will flash. If no operations are performed for approximately another
three minutes, the camera will turn off automatically.
While the camera is in standby mode, the monitor turns back on if you perform any of the following
operations:
➝ Press the power switch, shutter-release button, A (shooting mode) button, c (playback)
button, or b (e movie-record) button
2 9 m 0 s 2 9 m 0 s
9 7 0 9 7 0
• The time that elapses before the camera enters standby mode can be changed using the Auto off
setting in the setup menu (A 88).
• By default, the camera enters standby mode in about 30 seconds when you are using shooting
mode or playback mode.
• If you are using the optional AC Adapter EH-67, the camera enters standby mode after 30 minutes.
22
Downloaded from www.Manualslib.com
No operations
performed
manuals search engine
Flashes
No operations
performed
Camera enters
standby mode.
3 min
Camera turns off.