Operating the dishwasher
14
OPERATING THE DISHWASHER.
Plug the mains plug into a dedicated 15A
•
earthed wall socket.
Open the water tap.
•
Open the dishwasher door.
•
Load the dishes.
•
Check if both the upper and lower spray
•
arms rotate freely.
Add the required amount of detergent to
•
the dispenser and close the dispenser lid.
Close the dishwasher door.
•
Press the ON/OFF button
•
Check to see if water softening salt and/or
•
rinse aid need replenishing.
Select the desired washing programme.
•
Start the programme by pressing the Start/
•
Stop/Cancel button.
Monitor progress via the time remaining
•
display and the progress indicators.
The End of programme indicator will light
•
up.
Switch the machine off by pressing the
•
ON/Off button.
Close the water tap. (optional).
•
Remove the plug from the wall socket
•
(optional).
Open the door slightly and allow the
•
dishes to cool for about 15 minutes before
removing them.
The Door should not be left in the fully
•
open position as this could present a
tripping hazard.
Thereafter the clean dishes may be
•
removed.
WARNING
Never open the dishwasher door while it is
•
running.
Stop the dishwasher using the Stop/Start/
•
Cancel button.
Thereafter the door may be opened
•
Be careful to avoid the rush of hot steam
•
which may escape.
Fix whatever required fixing or which
•
necessitated the door being opened.
Close the door and press the Start/Pause/
•
Cancel button again.
The dishwasher will then resume operation.
Page 17