Adding Functions - Defy DDW172 Instruction Manual

ADDING FUNCTIONS TO THE
PROGRAMME
Half load and delayed start can be added to
an existing programme as follows:
Select the programme by pressing the
•
programme selection button (4).
Press the function button (5 or 6 or both).
•
Start the programme by pressing the
•
Start/Pause/Cancel button (2).
PROGRESS INDICATOR
The wash cycle may be monitored by
observing the progress indicators (15)
a= Washing.
•
b= Drying.
•
c= End of programme.
•
At the end of the programme, the indicator
•
lights up and the remaining time indicator
(3) displays 0:00.
CANCELING A PROGRAMME
Press the Start/Pause/Cancel button and
•
hold it down for three seconds to cancel a
programme that is running.
Release the
•
indicator (12) starts flashing.
After a few minutes. The machine will then
•
fulfill the
operation .
When the remaining time (11) displays
•
0:00 a new programme may be selected.
NOTE: Depending
programme was cancelled, there may be
detergent and rinse aid residues left in the
machine.
CHANGING A PROGRAMME
Press the Start/Pause/Cancel button (2) to
•
pause the machine.
Select the desired programme by pressing
•
the programme selection button (4).
Start the new programme by pressing the
•
Start/Pause/Cancel button (2) again.
The new programme will start where the
previous one left off. For example if the
previous one was in a rinse cycle, the new
one will resume in a rinse cycle. If you wish
the new programme to start from the
beginning ,you will first have to cancel the
previous programme as described under
"Canceling a programme".
Page 16
button when the
necessary cancellation
on when
SALT INDICATOR (9)
Please check the indicator (9) regularly.
•
If it lights up, the salt needs to be
replenished.
SETTING THE RINSE AID INDICATOR (10)
Using the rise aid indicator is optional and
this function may be switched on or off.
Proceed as follows:
The machine must be switched off.
•
Press and hold the 1/2 load button (5)
•
and then press the ON/OFF button (1)
to switch on.
Keep the 1/2 load button pressed in and
•
release the ON/OFF button.
Hold the 1/2 load button in for an
•
additional 3 seconds.
The Rinse aid indicator (10) will come
•
on and the stored status appears on the
display as ON or OFF.
You can change this status using the
•
Start/Pause/Cancel button .
Depending on the status ON or OFF
•
when the machine is switched off, it will
start remember the setting and either utilize
the indicator or not when next the
machine is switched on.
RINSE AID INDICATOR (10)
Please
•
regularly.
If it lights up, the rinse aid needs to be
the
•
replenished.
If the status of the indicator is OFF, it
•
will not show even if the rinse aid
container is empty.
check the indicator (10)