Using The Setup Wizard - D-Link DFL-260 Quick Manual

4.2 Using the Setup Wizard

The DFL-260 provides Web based configuration. You can
configure your DFL-260 through Internet Explorer 6 and later
or Firefox 1.0 and later browser in MS Windows, Macintosh or
UNIX based platforms. Activate your browser. Then type the
IP address of the DFL-260 into the Location/Address field and
press "Enter."
Open your Web
browser and type
https://192.168.1.1 /
into the URL address
box. Then press the
Enter or Return key.
Note:
DFL-260 allows either HTTP or a secure HTTPS connection from
any management host. However, for security reasons, by default
only a secure HTTPS connection is allowed. For more information
about configuring connection setting, please refer to the Firewall
User Manual.
(The IP Address shown in the example above is the default
setting. If you have changed the IP Address of the DFL-260
to conform to a network, then input that IP Address in the web
browser, instead of the default IP Address shown.)
Log on to the DFL-260 web interface.
To start using the DFL-260 web interface you need to log on
using the default username and password.
Type the default
Username/Password
Username: admin
Pasword: admin
and click Login
Note:
In order for the Setup Wizard to run properly, make sure IE Pop-Up
Blocker is turned off or click Temporarily Allow Pop-ups when the
Information Bar in IE notifies you that a pop-up has been blocked.
DFL-260 Quick Installation Guide
06