Service; Specific Safety Information; Laser Distance Meter Safety; Description, Specifications And Standard Equipment Description - RIDGID micro LM-100 Manual

• Use only accessories that are recommended by the manu-
facturer for your equipment. Accessories that may be suitable
for one piece of equipment may become hazardous when used
with other equipment
• Keep handles dry and clean; free from oil and grease. Allows
for better control of the equipment.

Service

• Have your equipment serviced by a qualified repair person
using only identical replacement parts. This will ensure that
the safety of the tool is maintained.

Specific Safety Information

This section contains important safety information that is
specific to this tool.
Read these precautions carefully before using the micro LM-
100 Laser Distance Meter to reduce the risk of eye injury or
other serious personal injury.
SAVE THESE INSTRUCTIONS!
Keep this manual with the tool for use by the operator.

Laser Distance Meter Safety

• Do not look into the laser beam. Looking into the laser beam
may be hazardous to the eyes. Do not look at the laser beam with
optical aids (such as binoculars or telescopes).
• Do not direct the laser beam towards other people. Make
sure the laser is aimed above or below eye level. Laser beams
may be hazardous to the eyes.
If you have any question concerning this Ridge Tool product:
• Contact your local RIDGID distributor.
WARNING
micro LM-100 Laser Distance Meter
• Visit www.RIDGID.com or www.RIDGID.eu to find your local
Ridge Tool contact point.
• Contact Ridge Tool Technical Services Department at rtctechser-
vices@emerson.com, or in the U.S. and Canada call (800) 519-
3456.
Description, Specifications
And Standard Equipment
Description The RIDGID
distance readings at the push of a button. You simply push the
measurement button to turn on the class II laser and point at the re-
mote or difficult to reach place to be measured to, then push the
measurement button again. The micro LM-100 provides a quick
measurement on a clear easy to read backlit LCD display.

Specifications

Range ...........................................0.05 to 50m*
Measuring Accuracy Up To 10m
(2, Standard Deviation).................Typically: ±1.5mm**
Measuring Units............................m, in, ft
Laser Class...................................Class II
Laser Type ....................................635 nm, <1 mW
Ingress Protection.........................IP 54 Dust Proof, Splash Proof
Memory.........................................20 Measurements
Operating Temperature.................0°C to 40°C (32°F to 104°F)
Storage Temperature ....................-10°C to 60°C (14°F to 140°F)
Battery Life ...................................Up to 4,000 Measurements
Ridge Tool Company
micro LM-100 provides simple, quick, and accurate
®
(0.16 ft to 164 ft*)
(± 0.06 in**)
5