Bang & Olufsen BEOSOUND 5 User Manual page 16

Music storage
If you use a NAS as music storage, you
must set up BeoSound 5 for it. From the
factory BeoSound 5 is set up for use with
the internal hard disk.
> Use the pointer to highlight MODE.
> Turn the wheel to select SETTINGS.
> Press twice and press GO.
> Use the pointer to highlight SERVICE
SETTINGS.
> Turn the wheel to select MUSIC STORAGE
and press GO.
> Turn the wheel to select BeoMaster 5
(internal hard disk) or a connected server
and press GO.
Bang & Olufsen recommends use of specific
Network Attached Storage devices, contact
your Bang & Olufsen retailer for further
information.
>> Service settings
Music server
In a setup with, for example, the
BeoSound 5 Encore also, you can set the
BeoSound 5 up to act as a music server,
in order for other devices to access the
contents.
> Use the pointer to highlight MODE.
> Turn the wheel to select SETTINGS.
> Press twice and press GO.
> Use the pointer to highlight SERVICE
SETTINGS.
> Turn the wheel to select MUSIC SERVER
and press GO.
> Turn the wheel to select YES and press
GO.
When the MUSIC SERVER function is
activated, the system will not enter 'suspend'
mode and the hard disk does not switch off.
16
Rebuild music server
This option is only available if the
internal hard disk is used as music server.
If for some reason the music stored on
the internal hard disk does not appear
for browsing, you can make a new scan
of the music on the internal hard disk.
> Use the pointer to highlight MODE.
> Turn the wheel to select SETTINGS.
> Press twice and press GO.
> Use the pointer to highlight SERVICE
SETTINGS.
> Turn the wheel to select REBUILD MUSIC
SERVER and press GO.
> Turn the wheel to select YES and press
GO.