Table Of Contents - Nuvo NV-T2FX Installation Manual

Congratulations on your purchase of the NuVo T2 dual Tuner. With the T2 Dual Tuner, broadcast music enters the twenty-first
century. Finally you can enjoy state-of-the-art, advanced radio and satellite receiver technology, with astonishingly clear
reception throughout the entire home.
Combined with the NuVo Concerto Whole Home Audio Distribution System, the T2 gives you the ultimate radio experience with
Radio Data Service. RDS displays artist and song information on the Concerto Display Pads, which means no more waiting to hear a
song title, only to be disappointed when the station cuts to a commercial. Interference Adaptive Signal Processing (IASP)
circuitry combined with NuVo's patent pending Remote Active Antenna provide remarkable radio reception, even when radio
stations are typically difficult to receive. The T2 XM satellite tuner provides the full range of stations direct into your home.
Listening selections are streamed in real time to all the Display Pads throughout the NuVo Concerto System. The included XM
antenna makes satellite reception for the home easy and reliable.
The T2 is packed with many powerful features, and is designed to integrate seamlessly with any distributed audio system. This
manual is a guide to making the installation complete, and for making the most of your T2 Tuner. When properly installed, the T2
will provide years of listening enjoyment.

Table of Contents:

Basic Features
Front Panel
Back Panel
RC3 Remote Control
I. Installing the NV-T2 Dual Tuner
Stereo Audio Conncetions
Direct IR Control
IR Pass-Thru
AM/FM and XM Antenna Input
Proper Location of the XM Antenna
Subscribing to the XM Service
II. Front Panel Menu Controls AM/FM
Exit Menu
Force Mono
Brightness
Advanced Settings
Operating Mode
Regional Setup
Fine-Tuning
Seek Threshold
Audio Settings
Auto-On
AUX Input
Noise Blanking
Rs232 Communication
III. Front Panel Menu Control XM
Signal Status
Info
Advanced Settings
Diagnostics
XM Display Button
Introduction
IV. Stand-alone Front Panel Use of the T2
page 6
page 7
page 8
page 9
page 9
page 10
page 11
page 12
V. Using the T2 with the Concerto NuVoNet
page 12
page 13
page 13
page 13
page 14
page 14
page 14
page 14
V. T2 Configuration Software
page 15
page 15
page 16
page 16
page 16
page 16
page 16
page 16
Troubleshooting
page 16
NV-T2DF Specifications
page 16
Page 4
Tuning a Desired Station
Step Tune Mode
Seek Tune Mode
Scan Tune Mode
Direct Numeric Tuning
Radio Data Service
Signal Strength/Stereo Indicator
Using the Memory Feature
Source Switching
Setting Up the Tuner for NuVoNet
Making Sure Your Concerto Is Ready
Making the Connection
Operating the T2 with the Concerto Display Pad
T
uning by Categories
Radio Data Service
Direct Numeric Entry Tuning
Source Switching
1.0 Start
2.0 Config
3.0 Presets
Advanced Settings
4.0 Advanced Config
5.0 Advanced Presets
6.0 Categories
7.0 Update System
page 17
page 17
page 17
page 17
page 17
page 18
page 18
page 18
page 19
page 19
page 20
page 20
page 20
page 20
page 20
page 21
page 21
page 22
page 23
page 25
page 25
page 26
page 28
page 30