Troubleshooting - Nuvo NV-T2FX Installation Manual

7.2 Successful Download: When the download is complete a
final window will appear indicating that all the information
has downloaded successfully. Actual download time will vary
based on your computer's processing capabilities.
7.2 Successful Download
Symptom
I can't control the Tuner A or Tuner B from Display Pads, even
though my Concerto Configuration has these tuners enabled
as sources in the Concerto Configuration I loaded.
My Tuner A or Tuner B display periodically says "Error no
Concerto Connected".
My Tuner A or Tuner B display periodically says "Error source
address not in Concerto Configuration".

Troubleshooting

Page 28
Remedy
(1) Does your Concerto Configuration have Tuner A or
Tuner B set up as a source using the provided T2
library?
(2) Is the Tuner configured for "Operating Mode"
matching the source numbers you set up in the
Concerto Configuration? This can be done from the
front panel MENU Adv. Settings selection, or with the
T2 Configurator.
(3) Is the T2 connected to the NuvoNet through your EZ-
Port?
Connect the Nuvonet IN port on the rear of the T2 to one of the
"Peripheral Device" ports on your Concerto EZ Port.
The source numbers assigned in your Concerto Configuration
do not match the "Operating Mode" selection for the tuner.
Change either one to match the other.