Advertisement
AMPLIFIER INSTALLATION
1. Find a suitable location in the vehicle to mount the amplifier.
2. Make sure there is sufficient air flow around the intended mounting
location.
3. Bolt the amplifier to the mounting surface.
4. Connect the power ground terminal to the nearest point on the
chassis of the car. Keep this ground wire less than one meter (39"}
in length. Use 4 gauge wire.
5. Connect the remote terminal to the remote output of the head unit
using 14 gauge.
6. Connect an empty fuse holder within 300mm (12"} of the battery and
4 gauge or larger high quality cable from this fuse to the amplifier
Location.
7. Make sure there is no fuse in this fuse holder. Then make the
connection to the "BATT" connection on the amplifier.
8.lf multiple amplifiers are being used, use cables (each with its own
fuse at the battery} or a #0 or a #2 cable from the fuse holder at the
battery to a distribution block at or near the amplifier's location.
9.Connect all line inputs and outputs using high-quality RCA-RCA
Cables.
10. Insert fuse(s} at the battery fuse holder(s}.
11. Recheck all connections before powering up.
12. Set all level controls to their least sensitive positions and set all
crossover controls, switches, etc. to the desired frequency or
position.
13. Once the system is powered up , set the volume control on the
head unit to about the 2 o'clock position, and then set all the
am pl if iers'level controls
for maximam output level
14. Further fine tuning of the various controls may be necessary to
obtain the desired results.
FUNCTIONAL DESCRIPTION
RDA753D (Control terminals)
RDA754D(Control terminals)
RDA755D (Control terminals)
REAR
....,.
HHI: 1'4>Hz
MAX
FRONT
5118
� �
rt�
��
RCA L I NE I NPUT
HI
1WI 40H1: 1-0l»tr:
lllOH 1 : 2AHI:
Advertisement
