Door Removal Instructions - Frigidaire FPHI2188PF Use & Care Manual

Hide thumbs Also See for FPHI2188PF:

Use & care manual (13 pages)

Use and care manual (33 pages)

Table of Contents

Tools Necessary:

Phillips

Socket

Wrench Set

Door removal and reversal instructions:

1. Remove toe grille.

2. Remove top hinge cover. Trace around the hinge with a soft

lead pencil. This makes reinstallation easier. Remove top

hinge and lift door off center hinge pin. Set door aside.

3. Unscrew center hinge pin using adjustable wrench and save

for reassembly. Ensure plastic washer stays on hinge pin.

4. Lift refrigerator door off of bottom hinge and set aside.

5. Remove center hinge and shim by removing inside screw

and loosening two outside screws enough to allow hinge

and shim to slide out. Tighten screws.

6. Loosen two outside screws on opposite side of refrigerator,

remove inside screw and install center hinge.

7. Remove two screws on bottom hinge with ⅜" socket wrench.

8. Install bottom hinge on opposite side with the two screws

removed from step 7.

9. Unscrew bottom hinge pin using adjustable wrench. Move hinge

pin to other hole in hinge and tighten with adjustable wrench.

10. Reverse door handles (see instruction on next page).

11. Move freezer and refrigerator door stops to opposite side.

Before starting screws, use an awl to puncture the foam.

12. Position refrigerator door onto bottom hinge pin and screw

center hinge pin through center hinge into top of door. Close

refrigerator door to help align hinge hole.

13. Tighten center hinge pin with adjustable wrench.

14. Remove cabinet and hinge hole plugs and move to opposite side.

15. Lower freezer door onto center hinge pin.

16. Close freezer door. Have an assistant lift up on opposite side

of door while tightening screws to install top hinge.

17. Flip toe grille and reinstall.

18. Plug in electrical power cord and turn refrigerator temperature

control to center position. Adjust setting as necessary.