After-Sales Service; E Number And Fd Number; Technical Data; Environmentally-Friendly Disposal - Bosch HMT75M624 Instruction Manual

Error message
The appliance is not in operation. A
cooking time appears in the display.
The microwave does not work.
It takes longer than before for the
food to heat up
The turntable makes a scratching or
grinding noise.
Microwave operation has been can-
celled for no apparent reason.
"M" appears in the display.

After-sales service

Our after-sales service is there for you if your appliance needs
to be repaired. We will always find the right solution in order to
avoid unnecessary visits from a service technician.

E number and FD number

When calling us, please give the product number (E no.) and
the production number (FD no.) so that we can provide you with
the correct advice. The rating plate bearing these numbers can
be found on the right-hand side when you open the appliance
door. To save time, you can make a note of the number of your
appliance and the telephone number of the after-sales service
in the space below, should it be required.
E no.
O
After-sales service
Please note that there will be a fee for a visit by a service
technician in the event of a malfunction, even during the
warranty period.
Please find the contact data of all countries in the enclosed
customer service list.
To book an engineer visit and product advice
0344 8928979
GB
Calls from a BT landline will be charged at up to
3 pence per minute. A call set-up fee of up to
6 pence may apply.
01450 2655
IE
0.03 € per minute at peak. Off peak 0.0088 € per
minute.
Rely on the professionalism of the manufacturer. You can
therefore be sure that the repair is carried out by trained service
technicians who carry original spare parts for your appliances.
This appliance corresponds to the standards EN 55011 and
CISPR 11. It is a Group 2, Class B product.
Group 2 means that microwaves are produced for the purpose
of heating food. Class B states that the appliance is suitable for
private households.
22
Possible cause
The rotary selector was actuated acciden-
tally.
The Start button was not pressed after set-
ting.
The door was not fully closed.
The Start button was not pressed.
The microwave power level setting was too
low.
A larger amount of food than usual has
been placed in the appliance.
The food was colder than usual.
Dirt or debris in the area around the turnta-
ble drive.
The microwave has a fault.
The appliance is in demo mode.
FD no.
Remedy/note
Press the Stop button.
Press the Start button or cancel the setting with
the Stop button.
Check whether food residue or debris is
trapped in the door.
Press the Start button.
Select a higher microwave power setting.
Double the amount – double the time.
Stir or turn the food during cooking.
Clean the roller ring and the recess in the cook-
ing compartment.
If this fault occurs repeatedly, please call the
after-sales service.
Press and hold the Start button and the Stop
button for approx. 7 seconds.
Demo mode is deactivated.

Technical data

Input voltage
Power consumption
Maximum output power
Microwave frequency
Fuse
Dimensions (HxWxD)
­ appliance
­ cooking compartment
VDE approved
CE mark

Environmentally-friendly disposal

Dispose of packaging in an environmentally-friendly manner.
This appliance is labelled in accordance with
European Directive 2012/19/EU concerning used
electrical and electronic appliances (waste electrical
and electronic equipment - WEEE). The guideline
determines the framework for the return and recycling
of used appliances as applicable throughout the EU.
220 - 230 V, 50 Hz
1270 W
800 W
2450 MHz
10 A
382 x 594 x 319 mm
221 x 308 x 298 mm
yes
yes