Power On; Configuring The Host Computer Via A Network - Bosch DVA-12T Quick Installation Manual

58 en | Power On
8

Power On

To power on the subsystem:
1.
2.
3.
4.
5.
9

Configuring the Host Computer via a Network

The first time you use the subsystem you have to set up your computer to access the
subsystem.
To set up the computer:
1.
2.
NOTICE!
If you do not use a cross over cable and connect the unit to a network, your network's subnet
mask may not allow you to access this IP address without some re-configuration.
3.
Windows
This procedure allows a connection to the subsystem even if your computer has different
network settings.
F.01U.027.801 | V5 | 2010.06
Install all the hardware components.
Make all the connections described above
Power on the network connecting devices such as the Ethernet switches.
Power on the subsystem by turning on both power switches on the rear panel of power
supply unit modules. For the location of the power switches, please see Figure 7.1.
Power on servers or host computers.
Attach a network cable from the DVA's Ethernet port (CH1) to a network.
or
Connect the computer with the subsystems's Ethernet port via a cross-over cable.
Access any computer on the network.
To access the subsystem simply access a shell or a DOS prompt on your host computer,
and enter the following command:
route add 192.168.0.100 <workstation IP number>
mask 255.255.255.255
Quick Installation Guide
RAID Subsystem DVA-12T
Bosch Sicherheitssysteme GmbH