NETGEAR GS716T Software Administration Manual page 91

To configure VLAN membership:
1. From the VLAN ID field, select the VLAN to which you want to add ports.
2. Click the orange bar below the VLAN Type field to display the physical ports on the switch.
3. Click the lower orange bar to display the LAGs on the switch.
4. To select the port(s) or LAG(s) to add to the VLAN, click the square below each port or LAG.
You can add each interface as a tagged (T) or untagged (U) VLAN member. A blank square
means that the port is not a member of the VLAN.
• Tagged: Frames transmitted from this port are tagged with the port VLAN ID.
• Untagged: Frames transmitted from this port are untagged. Each port can be an
untagged member of only one VLAN. By default, all ports are an untagged member of
VLAN 1.
In the following figure, ports g6, g7, g8, and LAG 1 are being added as tagged members
to VLAN 99.
GS716T and GS724T Gigabit Smart Switches
91